PC PRODUCTS
PC PRODUCTS 160114 PC-11 Instant Adhesive Clear 0.14 oz Bottle
Clear instant adhesive bonds fiberglass, metal, plastic, tile and wood with waterproof, impact-resistant strength in a 0.14 oz bottle
- TypeSealing Compound
- Instant bonds in seconds with cyanoacrylate formula
- Clear finish blends invisibly on any surface
- Precise 0.14 oz bottle controls every drop
- Bonds metal, plastic, wood and more
- Ready to use straight from the bottle
PC-11 Epoxy Adhesive
PC-11 is a two-part epoxy adhesive supplied in a 0.14 oz bottle for bonding fiberglass, metal, plastic, tile and wood. The resin and hardener are included for interior or exterior repairs. It suits DIY users and professionals needing a waterproof, impact-resistant bond.
Low odour and zero VOCs
The compound carries a low-odour formulation with 0 g/L VOC content. It offers a 30 minute working time before cure begins. Service temperature reaches 200 degrees F for continuous performance. California Proposition 65 warning applies for reproductive harm.
Marine-grade durability
Cured adhesive turns off-white and remains waterproof in wet environments. Coverage ranges from .8 to 6.42 sq ft depending on joint thickness. The small bottle suits targeted repairs rather than large-area sealing. Not for buyers who need high-volume dispensing.
Highlights
- Instant bonds in seconds with cyanoacrylate formula
- Clear finish blends invisibly on any surface
- Precise 0.14 oz bottle controls every drop
- Bonds metal, plastic, wood and more
- Ready to use straight from the bottle
Specifications
| Type | Sealing Compound |
|---|---|
| Brand | PC PRODUCTS |
Questions about this item
How do I apply the two-part epoxy adhesive and what step is most often missed?
Mix the resin and hardener thoroughly for the full 30 min working time; the step most often missed is incomplete blending, which prevents a full cure.
What replacement will this 0.14 oz bottle need once it is used up?
The bottle contains a single-use epoxy kit; after the resin and hardener are exhausted you must buy a new PC-11 kit.
At what temperature does the cured bond reach its maximum performance limit?
The cured adhesive is rated for a maximum performance temperature of 200 Degrees F.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
