We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Ivory-white nylon flange, 3-inch tapered cone with bevelled edge, for 1.9-inch pool rail

PayandPack

PayandPack 3" Surface Mount Base Anchor Flange for 1.9" Pool Rail (Ivory White, 1-Pack)

SKU CH-CY6K-4JTT0

Surface-mount anchor secures 1.9" OD pool rails to concrete or wood decks with included stainless-steel 304 hardware

  • TypePool Maintenance Tools
  • Fits 1.9" OD handrails with 1.93" tapered top ID
  • Surface-mounts on concrete or wood decks without anchor sockets
  • Includes 304 stainless steel screws, washers, anchors and hex wrench
  • Engineering nylon resists corrosion and UV for maintenance-free life
  • Tapered cone with arc bevel edge adds strength and kick safety

PayandPack 3" Surface Mount Base Anchor Flange

This PayandPack flange secures 1.9" outer-diameter pool handrails to concrete or wood decks. It replaces embedded anchor sockets with a surface-mounted design suited to composite or stainless-steel tubing. The ivory-white engineering-nylon body resists corrosion and UV exposure for maintenance-free service. One pack contains a single 3"-high base.

Practical limits of the 1.9" rail interface

The base accepts rails with a 1.90" outer diameter; its inner diameter runs from 1.9" at the bottom to 1.93" at the top. Rails outside that tolerance will not seat properly. The 5.13" base diameter sets the footprint on the deck, so spacing between multiple anchors must accommodate that width. No other rail sizes or deck types are supported.

Installation ease and common issues

Stainless-steel 304 ground screws, washers, plastic anchors, two hex socket head screws and a hex wrench are included; a 3/8" masonry bit is required for concrete. The taper-cone shape with circular arc bevel edges aids alignment and reduces foot-kicking hazards. Mis-drilling anchor holes or using rails beyond the 1.90" OD spec are the typical causes of loose or unsafe mounting.

Highlights

  • Fits 1.9" OD handrails with 1.93" tapered top ID
  • Surface-mounts on concrete or wood decks without anchor sockets
  • Includes 304 stainless steel screws, washers, anchors and hex wrench
  • Engineering nylon resists corrosion and UV for maintenance-free life
  • Tapered cone with arc bevel edge adds strength and kick safety

Specifications

TypePool Maintenance Tools

Questions about this item

Should I pick the 3-inch or 6-inch base for my 1.9-inch rail?

The 3-inch base secures 1.90 OD ladders; the 6-inch base covers all 1.90 OD pool and spa handrails, ladders and safety railing.

What does the 1.93-inch top inner diameter mean when the rail is installed?

The inner diameter tapers from 1.9 inches at the bottom to 1.93 inches at the top, so the 1.9-inch OD rail seats fully while the slight flare eases insertion and alignment.

What does the 5.13-inch base diameter cap in practice?

The 5.13-inch footprint spreads load across concrete or wood, and the three stainless 304 anchor sets with 3/8-inch masonry bits hold the flange against uplift and lateral force.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.