PAULINN 15A 125V NEMA 5-15 Y Splitter 18in Extension Straight Blade Plug
A 15A 125V NEMA 5-15 Y splitter with dual 18in cords and weatherproof flanged inlet for RV and marine shore power
- Amps15
- Standards/CertificationsNEMA
- Compatibility/FitmentAll, Crimp, type_b_3pin_na
- 15 amp 125 volt rating powers RV shore connections
- NEMA 5-15 Y splitter feeds two devices from one inlet
- 18 inch integrated cords reach recessed outlet boxes
- Nickel coated copper resists UV impact and abrasion
- ETL approved weatherproof covers protect contacts from rain snow dust
15 A 125 V NEMA 5-15 Y Splitter
This PAULINN splitter provides two 18-inch extension cords from a single straight-blade inlet. It is rated for 15 amps at 125 volts and uses a 2-pole, 3-wire configuration. The unit suits RV, marine, trailer and block-heater installations where a single shore-power connection must feed two devices.
Replaces single-outlet shore inlets
The integrated Y cable replaces a standard flanged inlet that only accepts one plug, letting you run two loads without adding a separate distribution box. The jump is worth it when your RV or boat has a single 15 A shore inlet but you need simultaneous power for a charger and a block heater or other accessory.
Sustained outdoor load behaviour
Nickel-coated copper contacts and a black nylon housing resist UV, impact and abrasion during continuous outdoor exposure. The weatherproof covers protect the contacts from rain, snow and dust while the plug is not in use, and the cord grip accepts 12-18 AWG conductors for a secure, long-term connection.
Highlights
- 15 amp 125 volt rating powers RV shore connections
- NEMA 5-15 Y splitter feeds two devices from one inlet
- 18 inch integrated cords reach recessed outlet boxes
- Nickel coated copper resists UV impact and abrasion
- ETL approved weatherproof covers protect contacts from rain snow dust
Specifications
| Amps | 15 |
|---|---|
| Standards/Certifications | NEMA |
| Compatibility/Fitment | All, Crimp, type_b_3pin_na |
Questions about this item
What size mounting holes does the flanged inlet need?
The inlet requires two mounting holes; the see-through wiring block lets you align them before securing the flange.
Which step do installers most often miss when wiring the Y splitter?
Many forget to fully seat each conductor in the colour-coded crimp-lock clamps before tightening, leaving a loose connection.
When should the weatherproof covers be replaced on this shore-power inlet?
Replace the covers if the seals crack, the hinges bind, or water reaches the contacts during a visual inspection.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Ideal 2011s Splice Connector For 2014 Bare Copper Pack 50
- Bare Copper
Bryant Locking Straight Blade Plug L6-20P 20A 250V 2.0HP Black/White 70620
- HAWA



