Partners Brand PB7021 Soldering Bags 1000

Small parts storage bags for retail and workshop use

These clear poly bags measure two by three inches inside and come in a pack of one thousand. The four mil thickness gives a sturdy feel while the single track zipper runs the full width to seal out dust and moisture. A pre punched hang hole in the lip lets you display the bags on hooks or pegs. They meet FDA and USDA requirements for direct contact applications.

Lightweight polyethylene construction runs cool

The thin film material adds no measurable heat or noise to a workbench or display area. No power is required and the bags impose no load on any electrical circuit. Reclosable design means each bag can be opened and closed repeatedly without degrading the seal. The clear walls keep contents visible so you can identify parts at a glance.

Reusable zip seal and hang hole simplify daily

The zipper track stays aligned after many cycles so small components stay contained during transport. Hang holes accept standard pegboard hooks or wire racks for vertical merchandising. Flat stacked storage takes minimal shelf space until the bags are needed. Clear film and food grade compliance make them suitable for hardware, fasteners, craft supplies or packaged food portions.