Panasonic
Panasonic PT-U1X86 Projector Lamp 160W 2,000 Hrs
A 160-watt UHM replacement lamp module with a 2,000-hour rated life, supplied as a complete housing for direct installation in compatible Panasonic projectors
- TypeUHM
- Wattage160W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 160W UHM bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards
- Genuine OEM components ensure reliable ignition
PT-U1X86 replacement lamp
The PT-U1X86 is a 160W UHM lamp module with housing, ready for direct installation in compatible Panasonic projectors. It is built for users who need a new lamp to restore original brightness after the factory unit reaches its rated life.
OEM vs compatible choice
The supplier offers three OEM versions — from the original bulb maker, from Panasonic, and from another OEM bulb manufacturer — plus a lower-cost compatible version using genuine OEM parts. All variants are manufactured to ISO 9001 standards and tested for ignition, voltage, beam performance and run-time, so the jump from a dimming lamp is reliable regardless of the version selected.
Sustained output behaviour
Rated at 2,000 hours, the lamp is designed to maintain consistent output across its service interval rather than only in the first few hours. Each unit undergoes strict quality checks for run-time and voltage stability, giving confidence that brightness will not drop off prematurely during extended projection sessions.
Highlights
- Ready-to-install module saves setup time
- 160W UHM bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards
- Genuine OEM components ensure reliable ignition
Specifications
| Brand | Panasonic |
|---|---|
| Type | UHM |
| Wattage | 160W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the PT-U1X86 lamp module include the housing so it fits directly into the projector?
Yes, the module is supplied as a fully assembled 160W UHM bulb inside its housing, ready to slide into the lamp compartment without extra parts.
What is the correct procedure for installing the ET-LAC80 lamp, and which step is often missed?
Power off the projector and let it cool, open the lamp cover, remove the old module, insert the new PT-U1X86 unit until it clicks, close the cover, then reset the lamp timer in the menu — the timer reset is the step most users forget.
When will the 160W UHM bulb need replacement, and what part is swapped?
The rated life is 2,000 hours; when brightness drops or the projector warns you, replace the entire PT-U1X86 lamp module (bulb plus housing) as a single unit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



