Panasonic
Panasonic PT-LW80NTE projector lamp 220W
A 220 W PT-LW80NTE replacement lamp module with a new Philips UHM bulb and housing, rated for 2,000 hours normal or 3,000 hours economy use
- TypeProjector Lamp
- Wattage220W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready-to-install module with genuine Philips UHM 220W bulb
- Up to 3000 hours lamp life in Economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with Panasonic PT-LW80NTE projector model
- OEM replacement lamp includes housing for easy installation
Ready-to-install replacement lamp
The Panasonic PT-LW80NTE is a new 220W projector lamp module that ships with the bulb already seated in its housing. It matches the original ET-LAB80 specification and is designed for direct installation in compatible Panasonic projectors. The unit is rated for 2000 hours in normal mode or 3000 hours in economy mode.
Suited for owners of the listed Panasonic models
This lamp fits users who need a factory-specification replacement without sourcing a bare bulb and housing separately. It is not intended for projectors that require a different wattage or connector layout, and buyers who need a higher-lumen or lower-power alternative should look at other part numbers.
Simple swap with minimal risk
Because the bulb comes pre-assembled in the housing, installation typically requires only opening the projector lamp door, removing the old module and sliding the new one into place. The most common issue is forgetting to reset the projector lamp timer after fitting the replacement, which can cause premature replacement warnings.
Highlights
- Ready-to-install module with genuine Philips UHM 220W bulb
- Up to 3000 hours lamp life in Economy mode
- Manufactured to ISO 9001 quality standards
- Compatible with Panasonic PT-LW80NTE projector model
- OEM replacement lamp includes housing for easy installation
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 220W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Which Panasonic projector models accept the PT-LW80NTE lamp module?
The PT-LW80NTE lamp module is built for Panasonic projectors that use the ET-LAB80 lamp code; check your projector manual to confirm it lists that part number before ordering.
Can I reuse my existing lamp housing when I replace the bulb?
This module arrives as a complete 220 W bulb-and-housing assembly, so no separate housing is required and the old housing should be recycled rather than reused.
How do I verify the new lamp is operating correctly after installation?
Reset the projector lamp timer, then confirm the menu shows zero hours and that brightness reaches the expected level for a 220 W UHM lamp in normal or economy mode.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



