Panasonic
Panasonic PT-LB20 projector lamp 155W 2000 Hrs
Replacement lamp module with 155W Osram UHM bulb and housing, rated for 2000 hours
- TypeProjector Lamp
- Wattage155W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 155 W Osram UHM bulb delivers rated brightness
- 2000-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards for reliability
- Direct-fit design matches Panasonic ET-LAB10 specification
Panasonic PT-LB20 155W replacement lamp
This 155W replacement lamp module fits Panasonic projectors that use the PT-LB20 designation. It ships as a complete assembly with a new Osram UHM bulb already mounted in the housing, so the unit is ready for immediate installation. The lamp is rated for 2,000 hours of operation.
For owners needing a direct-fit OEM module
Buyers who want a drop-in replacement without handling a bare bulb will find this pre-assembled unit convenient. It is not suitable for projectors that require a different wattage, connector or form factor, nor for users who prefer to replace only the bare bulb to reduce cost.
Simple housing swap with typical pitfalls
Installation consists of removing the old lamp housing and inserting the new module until it seats firmly. Common issues include forgetting to reset the projector’s lamp-hour counter after fitting the new unit and touching the bulb glass with bare fingers, which can shorten lamp life.
Highlights
- Ready-to-install module saves setup time
- 155 W Osram UHM bulb delivers rated brightness
- 2000-hour rated life reduces replacement frequency
- Built to ISO 9001 quality standards for reliability
- Direct-fit design matches Panasonic ET-LAB10 specification
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 155W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Which Panasonic projectors accept the PT-LB20 lamp module?
The PT-LB20 lamp module is built for Panasonic projectors that use the ET-LAB10 part number, including models such as the PT-LB20, PT-LB20U and PT-LB20E.
Will the 155W UHM bulb run in a projector that originally shipped with a lower-watt lamp?
No. The lamp draws 155W and is designed only for projectors engineered for that power level; using it in a unit rated for a different wattage can cause errors or damage.
How can I verify the lamp is operating correctly after installation?
Reset the projector's lamp-hour counter, then confirm the on-screen timer starts from zero and the image reaches full brightness without flicker or warning messages.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



