Panasonic
Panasonic PT-LB10NTE Projector Lamp 155W 2000 Hrs
Genuine Osram 155W UHM bulb in a ready-to-fit housing restores 2000-hour brightness to compatible Panasonic projectors
- TypeProjector Lamp
- Wattage155W
- Lamp Life2,000 Hrs.
- Ready-to-install module saves setup time
- 155 W UHM bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- ISO 9001 manufacturing ensures consistent quality
- OEM-compatible housing fits Panasonic projectors directly
Panasonic PT-LB10NTE Projector Lamp
This 155 W replacement lamp module fits compatible Panasonic projectors. It ships as a fully assembled bulb and housing so installation is straightforward. The unit is designed for users who need a direct OEM-specification replacement without extra assembly steps.
2,000-hour rated life at 155 W
The lamp delivers up to 2,000 hours of operation under normal use. Brightness will gradually decline as the lamp ages, and runtime may be shorter in high-output modes. It is not suited for users who require significantly longer intervals between replacements.
OEM bulb and ISO 9001 manufacturing
Each module uses a new Osram UHM bulb built to ISO 9001 quality standards. The lamp is tested for beam performance, ignition, voltage, connections and run-time before shipping. Buyers who need a bare bulb without housing or a lower-cost compatible alternative should look elsewhere.
Highlights
- Ready-to-install module saves setup time
- 155 W UHM bulb matches original brightness
- 2,000-hour rated life reduces replacement frequency
- ISO 9001 manufacturing ensures consistent quality
- OEM-compatible housing fits Panasonic projectors directly
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 155W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Will the 155W lamp module fit the same housing slot as the original ET-LAB10 unit I am replacing?
Yes, the PT-LB10NTE is built as a direct replacement module with identical housing dimensions and connector layout for Panasonic projectors that use the ET-LAB10 part number.
How can I verify the lamp is igniting correctly and delivering rated brightness after installation?
Reset the projector’s lamp-hour counter, run the unit for 10 minutes, then confirm the on-screen timer starts at zero and the image reaches full brightness without flicker or colour shift.
Does the box contain only the lamp module or are extra cables or filters included?
The package contains the fully assembled 155W bulb-and-housing module only; no cables, filters or tools are supplied.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



