Panasonic
Panasonic PT-EZ580L Projector Lamp 400W
A 400W replacement lamp module with a new Philips UHM bulb and housing, rated for 3000 hours normal or 4500 hours economy life
- TypeProjector Lamp
- Wattage400W
- Lamp Life3,000 Hrs.(Normal) - 4,500 Hrs. (Economy)
- Ready-to-install lamp module saves setup time
- Philips UHM 400W bulb delivers rated brightness
- 3,000 hrs normal life supports extended use
- 4,500 hrs economy mode reduces replacement frequency
- Manufactured to ISO 9001 quality standards
Ready-to-install lamp module
The Panasonic PT-EZ580L is a 400W replacement projector lamp supplied as a fully assembled bulb and housing. It matches the original ET-LAE300 specification and uses a Philips UHM bulb. The module is manufactured to ISO9001 standards and tested for beam performance, ignition, voltage and run-time.
Suits owners of the PT-EZ580L projector
This lamp fits the Panasonic PT-EZ580L projector and restores brightness when the original module reaches end of life. It is not intended for other projector models or for users who need a bare bulb without the housing.
Drops into the existing lamp compartment
Installation uses the projector's native lamp door and connector, so no extra tools or adapters are required. The 400W rating works with the projector's built-in power supply. Normal mode yields 3000 hours of operation; economy mode extends that to 4500 hours.
Highlights
- Ready-to-install lamp module saves setup time
- Philips UHM 400W bulb delivers rated brightness
- 3,000 hrs normal life supports extended use
- 4,500 hrs economy mode reduces replacement frequency
- Manufactured to ISO 9001 quality standards
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 400W |
| Lamp Life | 3,000 Hrs.(Normal) - 4,500 Hrs. (Economy) |
Questions about this item
Which Panasonic projector models accept the PT-EZ580L lamp module?
The PT-EZ580L lamp module is built for Panasonic projectors that use the ET-LAE300 lamp type. Check your projector manual for the ET-LAE300 part number to confirm fit before purchase.
How does the 400 W UHM bulb compare with the original lamp in an older Panasonic projector?
The replacement uses a new Philips UHM 400 W bulb matched to the original specifications, so brightness, colour balance and ignition voltage remain the same as the factory lamp.
What should I see in the projector menu to confirm the new lamp is recognised and counting hours correctly?
After installation, reset the lamp timer in the projector menu; the counter should start at zero and increment normally in both Normal and Economy modes.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



