Panasonic
Panasonic PT-DX820WU Projector Lamp 310W NSH
A ready-to-install 310 W NSH lamp module delivering 1500 hours standard or 2000 hours economic life
- TypeNSH
- Wattage310W
- Lamp Life1500 HOURS STANDARD MODE 2000 HOURS ECONOMIC MODE
- Ready-to-install module saves setup time
- 310 W NSH bulb matches original brightness
- 1 500 hours standard mode extends replacement cycle
- 2 000 hours economic mode lowers running cost
- Built to ISO 9001 quality checks for reliable ignition
Panasonic PT-DX820WU 310W NSH Lamp
This projector lamp module combines a new Ushio NSH 310W bulb with a complete housing for direct installation. It serves as a genuine replacement for the Panasonic ET-LAD70AW lamp used in PT-DX820WU projectors. The unit arrives fully assembled so no additional assembly is required before fitting.
Replaces Worn Original Lamp
Swap this module when the existing lamp reaches its rated hours or shows dimming and colour shift. The jump is worth it if the projector is used daily and downtime must be avoided. It is not suited for users who only need a bare bulb without the housing.
Steady Output Over Rated Life
In standard mode the lamp delivers consistent brightness for 1500 hours before replacement is due. Economic mode extends the usable period to 2000 hours while reducing power draw. Output remains stable across the rated span rather than dropping sharply after an initial burst.
Highlights
- Ready-to-install module saves setup time
- 310 W NSH bulb matches original brightness
- 1 500 hours standard mode extends replacement cycle
- 2 000 hours economic mode lowers running cost
- Built to ISO 9001 quality checks for reliable ignition
Specifications
| Brand | Panasonic |
|---|---|
| Type | NSH |
| Wattage | 310W |
| Lamp Life | 1500 HOURS STANDARD MODE 2000 HOURS ECONOMIC MODE |
Questions about this item
Which Panasonic projector models accept the PT-DX820WU lamp module with the ET-LAD70AW housing?
The PT-DX820WU lamp module with ET-LAD70AW housing is designed for the Panasonic PT-DX820WU projector.
How do I install the PT-DX820WU lamp module, and what step is often missed?
Power off and unplug the projector, allow it to cool, remove the lamp cover, loosen the securing screws, pull out the old module by its handle, insert the new ET-LAD70AW module until it seats firmly, tighten the screws, replace the cover, then reset the lamp timer in the menu — the timer reset is the step most often missed.
When will the 310 W NSH lamp need replacement, and what indicates end of life?
The lamp is rated for 1500 hours in standard mode or 2000 hours in economic mode; replace it when the projector warns of lamp end-of-life, brightness drops noticeably, or the lamp fails to strike.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



