Panasonic
Panasonic ET-SLMP21 projector lamp 150W 2000 Hrs
Genuine 150 W UHP replacement lamp module rated for 2,000 hours, supplied fully assembled for quick installation
- TypeProjector Lamp
- Wattage150W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled bulb and housing
- Bright 150W UHP output for clear projection
- Rated 2,000 hours of lamp life
- Built to ISO 9001 quality standards
- Genuine Panasonic ET-SLMP21 replacement module
Panasonic ET-SLMP21 150W replacement lamp
This Panasonic ET-SLMP21 module supplies a genuine 150W UHP bulb inside a pre-assembled housing. It is designed for Sanyo projectors that require the POA-LMP21 lamp type. The unit arrives ready for immediate installation without separate bulb handling.
Replaces a dim or expired original lamp
When the existing lamp reaches its rated 2,000 hours or shows reduced brightness, this module restores factory-level output. The jump is worth it if the projector is otherwise functional and the lamp is the only worn component.
Limited to the 2,000-hour rated lifespan
The UHP bulb is rated for 2,000 hours of typical use; actual runtime varies with operating mode and environment. The lamp cannot exceed this design limit and must be replaced again once the rated hours are reached.
Highlights
- Ready to install with pre-assembled bulb and housing
- Bright 150W UHP output for clear projection
- Rated 2,000 hours of lamp life
- Built to ISO 9001 quality standards
- Genuine Panasonic ET-SLMP21 replacement module
Specifications
| Brand | Sanyo |
|---|---|
| Type | Projector Lamp |
| Wattage | 150W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the ET-SLMP21 module ship as a complete housing with the 150 W UHP bulb already fitted?
Yes, the lamp module arrives fully assembled with the 150 W UHP bulb inside the housing so you can install it without handling the bare bulb.
What is the correct orientation step that installers sometimes miss when seating the ET-SLMP21 in a Sanyo projector?
Align the module’s guide rails with the projector’s slots and press evenly until the retaining screw clicks; forcing it at an angle can damage the connector.
After roughly 2 000 hours of use, what part of the ET-SLMP21 will need replacement?
The entire lamp module — housing and 150 W UHP bulb together — should be swapped once the rated 2 000 hour life is reached.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



