Owens Corning
Owens Corning 200243 Drain Trap Tan HAWA
Fiberglass pipe insulation with adhesive slit and ASJ facing operates from 0 to 1,000 degrees Fahrenheit
- TypeDrain Components
- MaterialHAWA
- ColorTan
- Reliable thermal protection with R-value 5 insulation
- Safe plenum-rated design meets 25/50 flame-smoke limits
- Wide temperature range from 0 to 1000 degrees F
- Quick installation using slit adhesive and flap closure
- Durable fiberglass construction with ASJ facing in tan
Tan drain-trap pipe insulation
Owens Corning 200243 is a pre-slit fiberglass tube with adhesive flap designed to wrap 3-1/8-inch copper piping in plumbing and HVAC systems. The tan ASJ facing provides a clean finish for exposed runs in mechanical rooms or residential basements.
R-5 thermal barrier from 0 to 1000 °F
The one-inch wall delivers an R-value of 5, limiting heat loss on hot-water lines and preventing condensation on chilled-water pipes across the full rated temperature span. Performance drops once the operating temperature exceeds the 1000 °F maximum or falls below 0 °F.
Plenum-rated slit tube with self-seal flap
Flame-spread index of 25 and smoke-developed index of 50 meet plenum requirements for air-handling spaces. The factory slit and adhesive flap allow quick installation without separate tape, though the rigid tube form cannot bend around tight elbows or irregular fittings.
Highlights
- Reliable thermal protection with R-value 5 insulation
- Safe plenum-rated design meets 25/50 flame-smoke limits
- Wide temperature range from 0 to 1000 degrees F
- Quick installation using slit adhesive and flap closure
- Durable fiberglass construction with ASJ facing in tan
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Color | Tan |
| Brand | Owens Corning |
| Model | 200243 |
Questions about this item
Will this 3 1/8 in. insulation fit over my existing 3 1/8 in. copper pipe?
Yes, the inside diameter of 3 5/32 in. is made for a 3 1/8 in. copper tube size, so it slides straight on.
How do I check the 1 in. wall is sealing properly after installation?
Press the slit closed so the adhesive flap bonds all round; no gaps means the R-5 rating is achieved.
Does the box contain tape or clamps, or do I buy them separately?
The slit has a built-in adhesive flap, so no extra tape or clamps are required for a standard fit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



