We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Four black PLA filament spools in a box

OVERTURE PLA Filament 1.75mm Black 4-Pack 4kg

SKU CH-X190-1TMQG

Four 1 kg spools of 1.75 mm black PLA with ±0.02 mm diameter accuracy, dried 24 hours and vacuum-sealed for clog-free printing

  • ColorBlack*4
  • MaterialPolylactic Acid
  • Diameter1.75
  • Weight4 kilograms
  • Consistent prints from ±0.02 mm diameter control
  • Clog-free extrusion with 24-hour dried, vacuum-sealed spools
  • Tangle-resistant feeding via larger core and manual winding check
  • Ready for most FDM printers using 1.75 mm PLA
  • Four 1 kg spools give 4 kg total material

Bundle Contents

This OVERTURE PLA bundle supplies four 1 kg spools of black 1.75 mm filament for a total of 4 kg. It suits makers, educators and small workshops that run FDM printers daily and want a single-colour stock that stays consistent across long print queues.

Print Consistency

Each spool is monitored by a built-in CCD camera with closed-loop extrusion control to hold diameter tolerance at ±0.02 mm. The material is dried for 24 hours and vacuum-sealed, while a patented anti-clog formula and a larger inside-diameter spool design reduce tangles and moisture-induced bubbles during extended sessions.

Printer Preparation

Verify that your machine accepts 1.75 mm PLA and can reach a nozzle temperature between 190 °C and 220 °C with a heated bed range of 25 °C to 60 °C. Ensure the cooling fan can run at 100 % and that the spool holder accommodates the larger inside-diameter core used on these reels.

Highlights

  • Consistent prints from ±0.02 mm diameter control
  • Clog-free extrusion with 24-hour dried, vacuum-sealed spools
  • Tangle-resistant feeding via larger core and manual winding check
  • Ready for most FDM printers using 1.75 mm PLA
  • Four 1 kg spools give 4 kg total material

Specifications

BrandOVERTURE
ColorBlack*4
MaterialPolylactic Acid
Diameter1.75
Weight4 kilograms

Questions about this item

Does the 1.75 mm PLA spool need a heated chamber or enclosure to avoid warping during long prints?

No enclosure is required; the material prints reliably at 190 °C - 220 °C nozzle temperature with a bed at 25 °C - 60 °C and 100 % fan cooling.

What printer hardware must I already have to use these four 1 kg spools?

Any FDM or FFF printer that accepts 1.75 mm filament and can reach 190 °C - 220 °C at the hot end with a bed capable of 25 °C - 60 °C.

Will the ±0.02 mm diameter tolerance work on an older printer that has a worn Bowden tube and standard brass nozzle?

Yes, the tight tolerance and clog-free formula feed consistently through standard 1.75 mm paths, including older Bowden setups and brass nozzles.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.