OSRAM
OSRAM P-VIP 210W projector lamp for Optoma HD28DSE
A 210 W projector lamp module with bulb and housing pre-assembled, rated for 4000 hours normal or 8000 hours economy use
- TypeProjector Lamp
- Wattage210W
- Lamp Life4,000 Hrs. (Normal) - 8,000 Hrs. (Economy)
- 210 W P-VIP lamp delivers bright projection
- 4,000 hours normal life extends replacement interval
- 8,000 hours economy mode reduces running cost
- ISO 9001 manufacturing ensures consistent quality
- Pre-assembled bulb and housing enables quick installation
Direct replacement for Optoma HD28DSE
This 210W projector lamp module arrives as a fully assembled bulb and housing, ready for immediate installation in the Optoma HD28DSE. It uses an OSRAM P-VIP bulb and matches the original manufacturer part number SP.77011GC01.
Lamp life in normal and economy modes
Rated output is 210W. The lamp delivers 4,000 hours in normal mode and 8,000 hours in economy mode, giving a clear measure of expected service intervals before replacement is required.
Consistent output over extended use
Each unit undergoes ISO 9001 quality checks for beam performance, ignition, voltage and run-time. The lamp is built to maintain stable brightness and reliable ignition throughout its rated lifespan rather than fading after a short burst.
Highlights
- 210 W P-VIP lamp delivers bright projection
- 4,000 hours normal life extends replacement interval
- 8,000 hours economy mode reduces running cost
- ISO 9001 manufacturing ensures consistent quality
- Pre-assembled bulb and housing enables quick installation
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 210W |
| Lamp Life | 4,000 Hrs. (Normal) - 8,000 Hrs. (Economy) |
Questions about this item
What does the 210W rating mean when the lamp is running inside the Optoma HD28DSE?
The 210W rating shows the electrical power the P-VIP bulb draws during operation, which determines the light output level the projector was designed for.
Which lamp interface or standard does this module use, and what does it limit?
The lamp uses the Optoma SP.77011GC01 module interface, which ensures correct electrical connection, alignment and ignition voltage for the HD28DSE.
What physical space and mounting does the assembled bulb-and-housing need to fit the projector?
The unit arrives as a complete housing matched to the HD28DSE chassis, so it slides into the lamp compartment and secures with the projector's existing latch.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



