OSRAM
OSRAM 69115 P-VIP 200/1.0 E54 200W dlp replacement lamp
A 200 W DLP replacement lamp delivering 9,000 lm with a 2,500-hour rated life
- TypeProjector Lamps
- 9,000 lumens at 200 W for bright projection
- 2,500-hour rated life at 200 W for extended use
- OEM original Osram bare bulb matches original cooling and driving
- Certified Osram partner supply ensures genuine component
- 180-day warranty coverage against defective products
Product identity
The OSRAM 69115 P-VIP 200/1.0 E54 is a 200 W bare DLP replacement lamp intended for front projectors that accept this specific bulb type. It suits owners who need a direct OEM-specification light source and are comfortable handling a bare bulb without a housing module. Buyers who require a pre-assembled lamp cartridge or a different wattage rating cannot use this item.
Build and fit
The lamp is supplied as a bare bulb only, so installation demands transferring it into the projector's existing housing and securing the E54 base correctly. Manufacturing follows OSRAM original standards to match the required cooling arrangement and driving mode, ensuring mechanical alignment with the socket. Improper seating or damage during the swap will void the 180-day defect coverage.
Thermal and electrical behaviour
At the rated 200 W the bulb delivers 9000 lm with a rated life of 2500 hours, reflecting the heat load and power draw the projector's cooling system is designed to manage. Stable operation depends on the host unit maintaining its specified airflow and voltage regulation throughout each session.
Highlights
- 9,000 lumens at 200 W for bright projection
- 2,500-hour rated life at 200 W for extended use
- OEM original Osram bare bulb matches original cooling and driving
- Certified Osram partner supply ensures genuine component
- 180-day warranty coverage against defective products
Specifications
| Brand | OSRAM |
|---|---|
| Type | Projector Lamps |
Questions about this item
What does the E54 base designation mean for fitting this lamp?
The E54 base is the mechanical and electrical interface that matches the projector's lamp socket; it ensures the 200 W P-VIP bulb seats correctly and aligns with the required cooling and driving setup.
What physical clearance is needed to install the bare 69115 bulb without its housing?
As a bare bulb it must be inserted into the projector's existing lamp cage; you need enough internal space to handle the quartz envelope without touching the reflector or the projector's optical block.
Which installation step is most often done incorrectly when replacing this bare DLP bulb?
Touching the quartz envelope with bare fingers leaves oils that create hot spots and shorten the 2 500 hour rated life; always wear clean gloves and avoid over-tightening the retaining screws.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



