Orion
Orion XTR1500.5 XTR Series 1500W 5-Channel Amp 2-in-1 accessory
A 1500 W five-channel car amplifier combining Class A/B for four speakers and Class D for a subwoofer, stable at two ohms and one ohm respectively.
- 1500 W total output drives a full system
- 125 W × 4 at 2 Ω plus 1000 W × 1 at 1 Ω
- Class A/B channels 1-4 and Class D channel 5 balance fidelity with efficiency
- Variable 50 Hz–5 kHz high-pass and 50 Hz–400 Hz low-pass crossovers shape every channel
- Remote bass knob lets you adjust subwoofer level from the driver seat
Versatile 5-channel car amplifier
The Orion XTR1500.5 combines Class A/B amplification on four channels with a Class D fifth channel for subwoofer duty. This hybrid design delivers both musical accuracy and high efficiency in a single chassis. It suits enthusiasts building a complete front-stage plus bass system from one amplifier.
1500 W total RMS output
Channels 1-4 each provide 125 W at 2 ohms while the fifth channel delivers 1000 W at 1 ohm. Bridging the front four channels down to 2 ohms is supported for higher per-channel power. The design runs out of headroom when loads drop below the rated impedances or when continuous demand exceeds the 1500 W combined rating.
1-ohm stable Class D subwoofer channel
The fifth channel maintains stable operation at 1 ohm, a decisive spec for builders planning low-impedance subwoofer configurations. If the intended subwoofer load is higher than 1 ohm, this specific stability advantage goes unused.
Highlights
- 1500 W total output drives a full system
- 125 W × 4 at 2 Ω plus 1000 W × 1 at 1 Ω
- Class A/B channels 1-4 and Class D channel 5 balance fidelity with efficiency
- Variable 50 Hz–5 kHz high-pass and 50 Hz–400 Hz low-pass crossovers shape every channel
- Remote bass knob lets you adjust subwoofer level from the driver seat
Specifications
No published specifications for this item yet.
Questions about this item
Will the Orion XTR1500.5's 125W per channel at 2 ohms match the power handling of my existing 2-ohm component speakers?
The amplifier delivers 125W RMS per channel on channels 1-4 at a 2-ohm load, so it will pair well with speakers rated for similar power at that impedance.
How can I confirm the Class A/B channels and Class D subwoofer channel are operating correctly after installation?
Verify sound output from all five channels, check that the protection LEDs remain off during playback, and use the remote bass knob to confirm the fifth channel responds to level adjustments.
Does the package include the remote bass knob and wiring, or do I need to purchase a separate installation kit?
The amplifier is packaged with the remote bass knob included; power, ground, speaker wire and RCA cables are not supplied and must be sourced separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
