Orion
Orion XTR1000.1D 1000W mono car amplifier
Mono Class D amplifier delivers 1080 W RMS at 1 ohm with adjustable low-pass crossover and remote gain control
- Amplifier ChannelsMono
- TypeAmplifiers
- FeaturesMono Channel
- Peak Power1000W
- Max Power1000W
- Delivers 1080 watts RMS into a 1 ohm load
- Class D efficiency keeps heat low in tight spaces
- Adjustable 30 to 300 Hz low-pass filter tailors bass response
- >90 dB signal-to-noise ratio ensures clean low-frequency output
- Phase control from 0 to 180 degrees aligns subwoofer timing
Monoblock Class D amplifier
The Orion XTR1000.1D is a mono Class D car amplifier rated for 1000W peak power. It delivers 1080 watts RMS at 1 ohm, 790 watts at 2 ohms and 510 watts at 4 ohms, all measured at .5 percent THD+N. The frequency response spans 15Hz to 250Hz with a signal-to-noise ratio exceeding 90dB.
Suits subwoofer systems needing 1-ohm stability
This amplifier suits installations that require a single high-power channel stable down to 1 ohm. Builders who need multiple channels or full-range frequency response should look at something else.
1-ohm RMS power rating decides fit
The 1080-watt RMS figure at 1 ohm is the specification that determines whether this amp matches the subwoofer load and output target. Verify the subwoofer impedance and power handling against this number before purchase.
Highlights
- Delivers 1080 watts RMS into a 1 ohm load
- Class D efficiency keeps heat low in tight spaces
- Adjustable 30 to 300 Hz low-pass filter tailors bass response
- >90 dB signal-to-noise ratio ensures clean low-frequency output
- Phase control from 0 to 180 degrees aligns subwoofer timing
Specifications
| Brand | Orion |
|---|---|
| Model | XTR1000.1D |
| Amplifier Channels | Mono |
| Part Number | XTR1000.1D |
| Type | Amplifiers |
| Features | Mono Channel |
| Peak Power | 1000W |
| Max Power | 1000W |
Questions about this item
What head-unit outputs or line-level converter do I need to feed the XTR1000.1D?
The amplifier accepts low-level RCA inputs, so a head unit with pre-amp outputs or a speaker-level to RCA converter is required to provide the signal.
Will the amp’s 15 Hz – 250 Hz frequency response and 12 dB low-pass filter integrate with my existing mid-bass drivers?
The built-in low-pass crossover adjusts from 30 Hz to 300 Hz at 12 dB per octave, letting you match the subwoofer roll-off to your mid-bass range for a smooth handover.
How can I confirm the XTR1000.1D is operating correctly after installation?
The front panel shows a blue power LED when the amp is on and a red protection LED if a fault occurs; with a healthy system only the blue light stays lit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
PAC APH-TY02 Speaker Connection Harness Toyota Lexus 18
- Car Stereo Add-Ons
The Wires Zone Platinum 1/0 AWG Ring Terminals Pair
- Connector and Termi…



