We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small black box with HDMI and ethernet ports, plus IR cables

Orei LLC

Orei LLC HD12-EX165-K 1x2 HDMI Extender Splitter 2 in 1 accessory

SKU CH-Z2RV-E7RZB

Sends one HDMI source to two displays over Cat6 cable up to 165 ft at 4K 30 Hz or 230 ft at 1080p 60 Hz with IR pass-through and powered receivers

  • Distributes one HDMI source to two displays over Cat6 cable
  • Extends 4K at 30 Hz up to 165 ft and 1080p at 60 Hz up to 230 ft
  • Powers both receivers through the cable so no extra adapters are needed
  • Includes IR kit for remote control of the source from the display end
  • Plug-and-play operation with EDID management and a local HDMI loop-out

1×2 HDMI extender-splitter over Cat6/7

This Orei unit sends one HDMI source to two displays simultaneously over shielded Cat6 or Cat7 cable. A local HDMI loop-out on the transmitter lets you keep a monitor at the source. Power-over-cable feeds both receivers so no extra adapters are required at the display ends.

Replaces separate splitter and extender boxes

One device handles both distribution and long-distance transport, reducing cable count and power bricks. The jump is worthwhile when runs exceed typical HDMI cable limits and you need two remote screens plus a local view from a single source.

Cat6/7 distance and resolution limits

4K at 30 Hz reaches 165 ft, while 1080p at 60 Hz extends to 230 ft. 2K at 60 Hz and 720p are also supported within the same cable runs. Beyond these distances or higher refresh rates at 4K the signal will not hold.

Highlights

  • Distributes one HDMI source to two displays over Cat6 cable
  • Extends 4K at 30 Hz up to 165 ft and 1080p at 60 Hz up to 230 ft
  • Powers both receivers through the cable so no extra adapters are needed
  • Includes IR kit for remote control of the source from the display end
  • Plug-and-play operation with EDID management and a local HDMI loop-out

Specifications

No published specifications for this item yet.

Questions about this item

What type and length of Ethernet cable does the HD12-EX165-K need for a 4K@30Hz run?

Shielded Cat6 or Cat7 cable is recommended; the 4K@30Hz signal reaches up to 165 ft over a single cable.

Which step is most often missed when connecting the IR kit for remote source control?

Buyers often forget to plug the IR blaster into the transmitter and the IR receiver into the receiver unit so commands travel back over the Cat6 link.

When will the power adapter or the Cat6 cables typically need replacement?

The dual-voltage adapter should be replaced if it no longer supplies 12 V to the transmitter; Cat6 cables need swapping only if damaged or if runs exceed 230 ft for 1080p@60Hz.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.