OPTOMA
OPTOMA TX551 projector lamp 180W P-VIP 5000-6000 hrs
Genuine compatible replacement lamp with 180W P-VIP bulb and housing, rated for 5000 to 6000 hours
- TypeProjector Lamp
- Wattage180W
- Lamp Life5,000 (Normal) - 6,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- 180W P-VIP lamp delivers reliable brightness
- 5000 hours normal mode or 6000 hours economy mode
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Optoma TX551 projectors
Genuine 180 W replacement lamp
The OPTOMA TX551 module supplies a new 180 W P-VIP bulb pre-fitted in its housing. It is built for owners of compatible Optoma projectors who need a drop-in replacement without separate bulb handling.
ISO 9001 manufacturing and ready-to-fit housing
Each unit is produced under ISO 9001 quality checks covering beam performance, ignition, voltage, connections and run-time. The assembled housing means the lamp installs in one step, reducing downtime and avoiding alignment issues.
Two economy settings extend usable life
Normal mode delivers 5000 hours of operation while economy mode stretches that to 6000 hours. Buyers who need longer continuous runtime per lamp or who run projectors in hard-to-reach locations will benefit from the selectable modes.
Highlights
- Ready to install with pre-assembled bulb and housing
- 180W P-VIP lamp delivers reliable brightness
- 5000 hours normal mode or 6000 hours economy mode
- Manufactured to ISO 9001 quality standards
- Genuine compatible replacement for Optoma TX551 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 180W |
| Lamp Life | 5,000 (Normal) - 6,000 (Economy) Hrs. |
Questions about this item
What projector models accept the TX551 lamp module?
The TX551 lamp module fits Optoma projectors that use the BL-FP180F lamp code; check your projector manual to confirm compatibility before purchase.
What does the TX551 lamp module include for installation?
The TX551 module arrives as a fully assembled 180W P-VIP bulb inside its housing, so no separate bulb handling or alignment is required during replacement.
How is the TX551 lamp installed and what step is often missed?
Power off and cool the projector, remove the lamp cover, swap the old module for the new TX551 unit, replace the cover, then reset the lamp-hour counter in the menu — the reset step is frequently forgotten.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



