OPTOMA
OPTOMA THEME-S HD930 Projector Lamp 300W 2000 Hrs
300 W replacement lamp with a 2 000-hour rated life, supplied as a complete housing for quick installation
- TypeProjector Lamp
- Wattage300W
- Lamp Life2,000 Hrs.
- Ready to install with fully assembled housing
- Bright 300W UHP lamp powers clear projection
- 2,000-hour rated life supports long use
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Replacement lamp module
The OPTOMA THEME-S HD930 projector lamp module delivers a fully assembled 300W UHP bulb inside its housing for direct installation. It serves owners of compatible Optoma projectors who need a new light source without separate bulb handling. Buyers who want a bare bulb without the housing cannot use this unit.
Sustained brightness output
The lamp is rated for 2,000 hours of operation at its specified 300W power draw, giving a clear expectation for long-term brightness stability. Performance remains consistent across that rated lifespan rather than fading after a short burst. Users who require a longer rated life will need a different lamp specification.
Build quality and fit
Each module is manufactured to ISO 9001 standards and undergoes checks for beam performance, ignition, voltage, appearance, connections and run-time. The pre-assembled housing ensures correct alignment and secure mounting during replacement. Installers who prefer to swap only the bare bulb will find this design unsuitable.
Highlights
- Ready to install with fully assembled housing
- Bright 300W UHP lamp powers clear projection
- 2,000-hour rated life supports long use
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 300W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
Does the 300 W lamp generate noticeable heat or fan noise during extended daily use?
The lamp draws 300 W, so the projector's cooling system will run while it is operating; expect normal warm air exhaust and fan sound during long sessions.
What existing projector hardware is required for this lamp to work?
It fits Optoma projectors that use the SP.83C01G001 module; the housing is pre-assembled so no extra parts or tools are needed.
Will this replacement lamp perform the same as the original in an older Optoma unit?
It is built to the same 300 W and 2 000 hour specifications as the factory lamp, so brightness and ignition behaviour match the original.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



