OPTOMA
Optoma SP.8VH01GC01 projector lamp 190W
A 190W replacement lamp module with Osram P-VIP bulb and housing, rated for 5000 hours normal or 6000 hours economy use
- TypeProjector Lamp
- Wattage190W
- Lamp Life5,000 Hrs. (Normal) - 6,000 Hrs. (Economy)
- Ready to install with pre-assembled bulb and housing
- 190 W P-VIP lamp delivers bright projection
- 5,000 hours normal life reduces replacement frequency
- 6,000 hours economy mode extends usable time
- Manufactured to ISO 9001 quality standards
Ready-to-install 190 W replacement lamp
The Optoma SP.8VH01GC01 is a new projector lamp module that ships with a 190 W Osram P-VIP bulb already seated in its housing. It is built for owners of compatible Optoma projectors who need a direct swap without handling a bare bulb.
Suits owners needing a drop-in module.
This unit fits users who want the complete lamp assembly so installation takes seconds. It is not for technicians or cost-conscious buyers who prefer to replace only the bare bulb and reuse the existing cage.
Tool-free swap in most Optoma models
The pre-assembled housing slides into the projector’s lamp compartment and locks with the existing latch, so no tools are required. The most common issue is forgetting to reset the lamp-hour counter in the projector menu after installation, which leaves the replacement warning active.
Highlights
- Ready to install with pre-assembled bulb and housing
- 190 W P-VIP lamp delivers bright projection
- 5,000 hours normal life reduces replacement frequency
- 6,000 hours economy mode extends usable time
- Manufactured to ISO 9001 quality standards
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 190W |
| Lamp Life | 5,000 Hrs. (Normal) - 6,000 Hrs. (Economy) |
Questions about this item
Which Optoma projectors accept the SP.8VH01GC01 190W lamp module?
This lamp module is built for Optoma projectors that specify the SP.8VH01GC01 part number; check your projector’s manual or service label to confirm the exact model match before ordering.
Can I keep using my existing ceiling mount and cables when I swap in this replacement lamp?
Yes — the lamp is a self-contained bulb-and-housing unit that slides into the projector’s lamp bay, so your current mount, power cord and signal cables all remain unchanged.
How do I verify the new lamp is operating correctly after installation?
Reset the lamp-hour counter in the projector menu, then confirm the lamp ignites steadily, the image is bright and uniform, and the counter begins tracking from zero toward the 5,000-hour normal or 6,000-hour economy rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



