OPTOMA
Optoma SP.8FE01GC01 projector lamp Osram P-VIP 200W
A 200 W Osram P-VIP lamp module rated for 3,000 hours normal or 4,000 hours economy use
- TypeProjector Lamp
- Wattage200W
- Lamp Life3,000 (Normal) - 4,000 (Economy) Hrs.
- Ready to install with pre-assembled bulb and housing
- Bright 200W Osram P-VIP lamp for clear projection
- Up to 4,000 hours lamp life in Economy mode
- 3,000 hours lamp life in Normal mode
- Manufactured to ISO 9001 quality standards
Direct replacement lamp
The Optoma SP.8FE01GC01 is a new projector lamp module supplied with a 200 W Osram P-VIP bulb already fitted in its housing. It is designed for owners of compatible Optoma projectors who need a ready-to-install light source when the original lamp reaches end of life.
Pre-assembled housing
The unit arrives as a complete lamp-and-housing assembly, so no separate bulb handling or alignment is required during installation. Manufacturing follows ISO 9001 quality checks covering beam performance, ignition voltage, connections and run-time to ensure reliable operation in daily use.
Restores original brightness
Replacing a dimmed or expired lamp with this module returns the projector to its factory light output for up to 3,000 hours in normal mode or 4,000 hours in economy mode. It is not suited for users who require a higher-wattage light engine or a different lamp technology than the specified 200 W P-VIP design.
Highlights
- Ready to install with pre-assembled bulb and housing
- Bright 200W Osram P-VIP lamp for clear projection
- Up to 4,000 hours lamp life in Economy mode
- 3,000 hours lamp life in Normal mode
- Manufactured to ISO 9001 quality standards
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 200W |
| Lamp Life | 3,000 (Normal) - 4,000 (Economy) Hrs. |
Questions about this item
What is the wattage of the Osram P-VIP bulb inside this Optoma SP.8FE01GC01 module?
The module uses a 200W Osram P-VIP bulb, which determines the light output and power draw of the replacement lamp.
Does the Optoma SP.8FE01GC01 arrive as a complete housing assembly or as a bare bulb?
It is supplied as a fully assembled bulb and housing, so no separate cage installation is required before fitting it to the projector.
How is the Optoma SP.8FE01GC01 lamp module installed, and what step is often missed?
Power off and cool the projector, open the lamp door, release the securing screws, swap the module, re-tighten the screws, close the door, then reset the lamp-hour counter in the menu — the reset is the step most often forgotten.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



