OPTOMA
OPTOMA SP.71P01GC01 projector lamp 190W
A 190W projector lamp module with Osram P-VIP bulb and housing, rated for 5000 hours normal or 6000 hours economy use
- TypeProjector Lamp
- Wattage190W
- Lamp Life5,000 Hrs. (Normal) - 6,000 Hrs. (Economy)
- Genuine Osram P-VIP 190W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- 5000 hours normal lamp life reduces replacement frequency
- 6000 hours economy mode extends usable runtime
- ISO 9001 manufacturing ensures consistent quality control
What this lamp replaces
The Optoma SP.71P01GC01 is a new 190W projector lamp module supplied with a pre-assembled Osram P-VIP bulb inside its housing. It is intended for owners of compatible Optoma projectors who need a direct replacement when the original lamp reaches end of life.
Wattage and rated life
The lamp draws 190W and is rated for 5000 hours in normal mode or 6000 hours in economy mode. Buyers whose projector requires a different wattage or a longer rated life should verify the service manual before ordering.
Installation and common issues
The unit arrives fully assembled so installation typically means opening the lamp door, removing the old module and sliding this one in until it seats. The most frequent problem is forgetting to reset the projector’s lamp-hour counter after the swap, which leaves the replacement warning active.
Highlights
- Genuine Osram P-VIP 190W bulb delivers reliable brightness
- Pre-assembled housing enables quick tool-free installation
- 5000 hours normal lamp life reduces replacement frequency
- 6000 hours economy mode extends usable runtime
- ISO 9001 manufacturing ensures consistent quality control
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 190W |
| Lamp Life | 5,000 Hrs. (Normal) - 6,000 Hrs. (Economy) |
Questions about this item
How many hours will the 190W lamp last before I need another one?
The lamp is rated for 5,000 hours in normal mode and 6,000 hours in economy mode, so actual life depends on which setting you use.
Does the module plug straight into the projector or does it need extra wiring?
It arrives as a fully assembled bulb and housing unit that fits directly into the projector lamp compartment with no additional cabling.
What clearance does the housing need inside the projector chassis?
The housing is built to the original SP.71P01GC01 form factor, so it occupies the same space as the factory lamp and requires no extra room.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



