OPTOMA
Optoma OP5050 projector lamp 330W P-VIP bulb housing
330W P-VIP replacement lamp module with housing for Optoma projectors, rated 2,000 to 3,000 hours
- TypeProjector Lamp
- Wattage330W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready-to-install module with genuine Osram P-VIP 330W bulb
- Up to 3,000 hours lamp life in Economy mode
- Manufactured to ISO 9001 quality standards
- Direct OEM replacement for Optoma OP5050 projectors
- Tested for beam performance, ignition and run-time reliability
Direct replacement for Optoma projectors
The OP5050 lamp module ships as a complete housing with a 330W P-VIP bulb inside, so it fits straight into compatible Optoma projectors without extra assembly. It is aimed at owners who need a factory-specification light source to restore original brightness and colour accuracy.
Assembled housing with OEM-grade bulb
The unit arrives fully assembled, reducing installation to a single swap and minimising the risk of dust entering the optical path. Manufacturing follows ISO 9001 quality checks covering beam performance, ignition voltage, connections and run-time, so the lamp behaves consistently from first strike.
Restores output after 2,000 to 3,000 hours of use
Normal-mode life is rated at 2,000 hours and economy mode extends that to 3,000 hours, giving a clear interval for planned replacement. The jump is worth it when image dimming or colour shift becomes noticeable, but it does not add higher resolution or new connectivity.
Highlights
- Ready-to-install module with genuine Osram P-VIP 330W bulb
- Up to 3,000 hours lamp life in Economy mode
- Manufactured to ISO 9001 quality standards
- Direct OEM replacement for Optoma OP5050 projectors
- Tested for beam performance, ignition and run-time reliability
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 330W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
What projector model does the OP5050 lamp module fit?
The OP5050 module is built for Optoma projectors that use the BL-FP330B lamp type; it ships as a complete bulb-and-housing assembly so it drops straight into the existing lamp cage.
How is the lamp secured inside the projector?
The pre-assembled housing slides into the lamp compartment and is held by the projector's retaining screw; the step people miss is forgetting to tighten that screw before closing the cover.
What is the correct way to reset the hour counter after installation?
After fitting the new 330 W module, use the projector's menu to reset the lamp timer to zero; skipping this leaves the counter running on the old bulb's hours.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



