We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Optoma NOBO S15E projector lamp module with 200W bulb in housing

OPTOMA

OPTOMA NOBO S15E projector lamp 200W 2000 Hrs

SKU CH-EJQJ-472HW

200 W replacement lamp module with 2 000-hour rated life for Optoma projectors

  • TypeProjector Lamp
  • Wattage200W
  • Lamp Life2,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • Bright 200W Phoenix NSH lamp powers your Optoma projector
  • Rated 2000 hours of projection time before replacement
  • Manufactured to ISO9001 quality standards for reliable performance
  • Compatible replacement for Optoma model SP.80V01.001

Ready-to-install lamp module

The OPTOMA NOBO S15E is a complete projector lamp assembly that combines a new 200W Phoenix NSH bulb with its housing. It arrives fully assembled for direct replacement in compatible Optoma projectors without additional handling.

Suited for standard-cycle replacements

This module targets users who need a straightforward 2,000-hour lamp swap for routine maintenance. It is not intended for buyers who require extended-life lamps rated for significantly longer run-times or higher-wattage alternatives.

Fits existing projector housing

The unit slots into the projector’s original lamp compartment using the factory mounting points and power connector. No extra brackets, cables or tools are needed, leaving the surrounding optics and cooling layout unchanged.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • Bright 200W Phoenix NSH lamp powers your Optoma projector
  • Rated 2000 hours of projection time before replacement
  • Manufactured to ISO9001 quality standards for reliable performance
  • Compatible replacement for Optoma model SP.80V01.001

Specifications

TypeProjector Lamp
Wattage200W
Lamp Life2,000 Hrs.

Questions about this item

Which Optoma projectors accept the SP.80V01.001 lamp module?

The SP.80V01.001 module fits Optoma projectors that specify the NOBO S15E lamp; check your projector's manual or original lamp label for that exact part number before ordering.

Will the 200 W Phoenix NSH bulb match the brightness and ignition timing of the original lamp?

The replacement uses a genuine 200 W Phoenix NSH bulb built to ISO 9001 quality checks for beam performance, ignition, voltage and run-time, so it reproduces the original output.

How can I confirm the new lamp is operating correctly after installation?

Reset the projector's lamp-hour counter, then verify the on-screen timer starts from zero and the image reaches full brightness without flicker or error messages.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.