OPTOMA
OPTOMA H5085 Projector Lamp 280W P-VIP
Genuine 280W P-VIP replacement lamp module with housing, rated 2,000 normal or 3,000 economy hours
- TypeProjector Lamp
- Wattage280W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Genuine 280 W P-VIP bulb delivers reliable brightness
- Up to 3,000 hours lamp life in Economy mode
- Ready-to-install housing enables quick replacement
- Manufactured to ISO 9001 quality standards
- Compatible with Optoma H5085 projectors
Genuine Optoma H5085 replacement lamp
The Optoma H5085 is a new 280W P-VIP projector lamp module supplied with the bulb pre-installed in its housing. It is designed as a direct replacement for the BL-FP280C lamp used in compatible Optoma projectors. The unit arrives ready for tool-free installation, restoring original brightness without additional alignment.
For owners of compatible Optoma projectors
This lamp suits users who need a factory-specification 280W P-VIP module to return their projector to its rated output. It is not for buyers who require a different wattage, an alternative lamp technology, or a bare bulb without the housing assembly.
Rated 2000 hours normal and 3000 hours economy
Under continuous operation the lamp delivers approximately 2000 hours at normal brightness before reaching its rated end of life. Switching to economy mode extends the rated lifespan to around 3000 hours while reducing light output. Both figures represent manufacturer estimates for sustained use rather than short-term peaks.
Highlights
- Genuine 280 W P-VIP bulb delivers reliable brightness
- Up to 3,000 hours lamp life in Economy mode
- Ready-to-install housing enables quick replacement
- Manufactured to ISO 9001 quality standards
- Compatible with Optoma H5085 projectors
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 280W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
Which Optoma projector models accept the BL-FP280C lamp module?
The BL-FP280C module is built for the Optoma H5085 projector. Verify your projector model number matches before ordering.
Can I reuse the existing lamp housing when replacing the 280W P-VIP bulb?
This module ships as a fully assembled bulb and housing. No reuse of the old housing is required; simply swap the complete unit.
How do I confirm the new lamp is operating correctly after installation?
Reset the lamp-hour counter in the projector menu, then check that the displayed hours start from zero and that brightness meets the 2000-hour normal or 3000-hour economy rating.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



