We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Optoma H27 projector lamp module with 200W bulb in housing

OPTOMA

Optoma H27 projector lamp 200W 2000 Hrs

SKU CH-S0TQ-1VCC7

A 200 W replacement lamp module rated for 2,000 hours, supplied as a complete bulb-and-housing assembly for Optoma projectors

  • TypeProjector Lamp
  • Wattage200W
  • Lamp Life2,000 Hrs.
  • Ready to install with pre-assembled bulb and housing
  • 200W Phoenix SHP bulb delivers specified brightness
  • 2,000 hour rated lamp life for extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance, ignition and run-time

Ready-to-install replacement lamp module

The Optoma H27 projector lamp ships as a fully assembled 200W bulb inside its housing. It matches the original SP.80N01.001 specification and requires no separate alignment or assembly before fitting. Buyers who need a bare bulb without housing or a different wattage rating should look elsewhere.

Consistent output for the rated 2000 hours

The Phoenix SHP 200W bulb is built to ISO9001 quality checks covering ignition, voltage stability and run-time. Light output and colour balance remain steady across the full 2000-hour service life rather than fading after an initial burst. Installations that demand longer uninterrupted cycles or higher single-lamp brightness will exceed this module's design limits.

Direct-fit interface for compatible Optoma models

The housing uses the exact connector and mounting points specified for the H27 series, so installation is a simple swap. Projectors outside the H27 compatibility list cannot accept this module mechanically or electrically. Users needing multi-lamp redundancy or networked lamp monitoring must rely on the projector's own features, as the lamp itself provides no communication interface.

Highlights

  • Ready to install with pre-assembled bulb and housing
  • 200W Phoenix SHP bulb delivers specified brightness
  • 2,000 hour rated lamp life for extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance, ignition and run-time

Specifications

TypeProjector Lamp
Wattage200W
Lamp Life2,000 Hrs.

Questions about this item

How much heat and power does the 200W Phoenix SHP bulb produce during continuous daily use?

The 200W rating defines its power draw and heat output; the lamp is rated for 2,000 hours of operation under normal projector cooling.

Does the H27 module arrive fully assembled so I only need the compatible Optoma projector?

Yes, the H27 lamp module (SP.80N01.001) includes the Phoenix SHP 200W bulb pre-installed in its housing for direct installation.

Will this replacement lamp match the brightness and ignition performance of the original lamp in my older Optoma projector?

Each H27 lamp undergoes ISO9001 checks for beam performance, ignition, voltage and run-time to meet original specifications.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.