OPTOMA
OPTOMA GT1080Darbee projector lamp 190W P-VIP
190 W P-VIP replacement lamp module with housing for easy Optoma GT1080Darbee installation
- TypeP-VIP
- Wattage190W
- Ready to install with pre-assembled bulb and housing
- 190 W P-VIP lamp matches original brightness
- Manufactured to ISO 9001 quality standards
- Genuine Osram bulb ensures reliable ignition and run-time
- Direct OEM replacement for Optoma GT1080Darbee
Direct replacement lamp
The OPTOMA GT1080Darbee projector lamp is a 190W P-VIP module built with a new Osram bulb inside a complete housing. It matches the original BL-FP195B specification so the projector recognises it immediately and restores factory brightness. Home-cinema owners and gamers using the GT1080Darbee model get a true plug-and-play refresh without adapter cables or firmware updates.
Upgrade from a dim or failed lamp
Replace the lamp when the image has noticeably faded, colours look washed out or the projector warns that lamp hours are exhausted. The jump is worth it when the current bulb no longer delivers the contrast needed for dark scenes or low-lag gaming. Buyers who need a higher-wattage or different-form-factor module for another projector model cannot use this unit.
Tool-free housing swap
The fully assembled housing slides into the projector after removing the lamp cover, usually secured by one or two screws. No bulb handling or alignment is required, so the risk of contaminating the quartz envelope is eliminated. The most common mistake is forgetting to reset the lamp-hour counter in the menu, which leaves the replacement warning active.
Highlights
- Ready to install with pre-assembled bulb and housing
- 190 W P-VIP lamp matches original brightness
- Manufactured to ISO 9001 quality standards
- Genuine Osram bulb ensures reliable ignition and run-time
- Direct OEM replacement for Optoma GT1080Darbee
Specifications
| Brand | OPTOMA |
|---|---|
| Type | P-VIP |
| Wattage | 190W |
Questions about this item
What projector models does the BL-FP195B lamp module fit?
The BL-FP195B lamp module is built for the Optoma GT1080Darbee projector and ships as a complete housing assembly.
What is the common mistake when installing this lamp module?
Installers often forget to remove the protective film from the Osram P-VIP 190 W bulb face before securing the housing.
Which component will need replacement after the bulb reaches end of life?
The entire BL-FP195B lamp module, including the Osram P-VIP 190 W bulb and housing, is replaced as one unit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



