We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
New Optoma EzPro 739H projector lamp module with 200W Phoenix SHP bulb in housing

OPTOMA

OPTOMA EzPro 739H projector lamp 200W 2000 Hrs

SKU CH-6DKN-DEAKT

200 W replacement lamp module with housing for Optoma EzPro 739H projectors, rated for 2,000 hours of use

  • TypeProjector Lamp
  • Wattage200W
  • Lamp Life2,000 Hrs.
  • Ready-to-install module with bulb and housing
  • 200W Phoenix SHP bulb delivers specified brightness
  • 2,000-hour rated lamp life for extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance, ignition and voltage

Ready-to-install 200W replacement module

The OPTOMA EzPro 739H lamp ships as a fully assembled 200W bulb and housing unit. It fits the Optoma projector without extra assembly steps. The module uses a Phoenix SHP lamp built to ISO9001 quality checks. Buyers who need a higher-wattage or different-base lamp cannot use this unit.

Consistent output over 2,000-hour rating

The 200W SHP bulb maintains stable ignition and beam performance across its 2,000-hour rated life. Each lamp passes voltage, run-time and appearance tests before shipment. Brightness will gradually decline as hours accumulate rather than dropping abruptly. Users who run projectors continuously for longer cycles should plan for earlier replacement.

Direct housing swap with no tools

Installation requires only opening the projector lamp door and sliding the module into place. The pre-assembled housing eliminates bulb-alignment errors that cause ignition failure. A loose door latch or dust on the connector are the most common reasons a new lamp will not strike. Keep the old housing until the new one confirms operation.

Highlights

  • Ready-to-install module with bulb and housing
  • 200W Phoenix SHP bulb delivers specified brightness
  • 2,000-hour rated lamp life for extended use
  • Manufactured to ISO 9001 quality standards
  • Tested for beam performance, ignition and voltage

Specifications

TypeProjector Lamp
Wattage200W
Lamp Life2,000 Hrs.

Questions about this item

How much heat and power does the 200W bulb add when the projector runs all day?

The lamp draws 200W, so that power becomes heat inside the projector; the cooling fans will run continuously to manage the temperature.

What must I already own for this module to work?

You need an Optoma EzPro 739H projector, because the lamp housing is built to match that model's SP.80N01.001 slot.

Will the Phoenix SHP 200W bulb perform the same as the original lamp in my older EzPro 739H?

Yes, the module uses a genuine Phoenix SHP 200W bulb rated for 2,000 hours and is manufactured to ISO 9001 standards, so brightness, ignition and run-time match the original specification.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.