OPTOMA
OPTOMA EP7479 Projector Lamp 230W 2000 Hrs
A 230W replacement projector lamp module with a 2000-hour rated life, supplied as a complete housing for direct installation
- TypeProjector Lamp
- Wattage230W
- Lamp Life2,000 Hrs.
- Ready to install with pre-assembled housing
- 230 W Osram P-VIP bulb delivers rated brightness
- 2 000-hour lamp life supports extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Optoma projectors using SP.83R01G.001
Ready-to-Install Lamp Module
The Optoma EP7479 is a new 230W replacement projector lamp supplied as a complete bulb-and-housing assembly. It fits directly into compatible Optoma projectors without any extra assembly or alignment steps. Buyers who need a bare bulb only or a different wattage will not find that option here.
OEM and Compatible Versions
Depending on stock, up to four versions are offered: three OEM variants sourced from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita, plus a third-party compatible built with genuine OEM parts. Each unit is manufactured to ISO9001 standards and tested for beam performance, ignition, voltage and run-time. Buyers who require a specific original manufacturer for this model cannot be guaranteed that version.
230W Output and 2000-Hour Rating
The lamp delivers 230W of power with a rated life of 2000 hours under normal operating conditions. It is designed to restore full brightness and colour accuracy for the projector models that specify this part. Installations that demand higher wattage or longer rated life will exceed what this module provides.
Highlights
- Ready to install with pre-assembled housing
- 230 W Osram P-VIP bulb delivers rated brightness
- 2 000-hour lamp life supports extended use
- Manufactured to ISO 9001 quality standards
- Compatible with Optoma projectors using SP.83R01G.001
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 230W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
What housing does the EP7479 lamp module include?
The module is a fully assembled bulb and housing unit ready for direct installation in the projector.
What is the correct procedure to install the EP7479 lamp?
Power off and cool the projector, remove the lamp cover, release the retaining screws, swap the module, re-tighten screws, replace the cover, then reset the lamp timer in the menu.
How many hours is the Osram P-VIP 230W bulb rated for?
The lamp life is rated at 2,000 hours under normal operating conditions.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



