OPTOMA
OPTOMA EP708 projector lamp 230W 2000 Hrs
A 230 W projector lamp rated for 2,000 hours of use, supplied as a complete bulb-and-housing module for straightforward replacement
- TypeProjector Lamp
- Wattage230W
- Lamp Life2,000 Hrs.
- Ready-to-install module with bulb and housing
- 230 W UHP lamp delivers 2 000 hours runtime
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
- Direct from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
Genuine 230W replacement lamp module
The OPTOMA EP708 is a new projector lamp assembly that combines a 230W UHP bulb with its housing. It is intended for owners of compatible Optoma projectors who need a direct replacement when the original lamp reaches its rated end of life.
Ready-to-install housing frees up alignment time
The module arrives fully assembled so no separate bulb handling or housing re-use is required. It fits the projector's existing lamp compartment and connects to the standard power interface without adapters or firmware updates.
Rated 2000 hours at full 230W output
Under continuous operation the lamp maintains specified brightness for approximately 2000 hours before replacement is recommended. Output gradually declines over that period rather than dropping sharply after a short burst.
Highlights
- Ready-to-install module with bulb and housing
- 230 W UHP lamp delivers 2 000 hours runtime
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and voltage
- Direct from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
Specifications
| Type | Projector Lamp |
|---|---|
| Wattage | 230W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How long will the 230W UHP lamp last before I need to replace it?
The lamp is rated for 2000 hours of use before replacement is required.
Does the 230W lamp generate much heat or fan noise during extended operation?
The 230W UHP lamp produces significant heat, so the projector’s cooling fans will run audibly during all-day use.
Will this EP708 module fit my Optoma projector without extra parts?
Yes, the lamp arrives as a fully assembled bulb and housing matching Optoma part SP.88R01G.C01 for direct installation.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



