OPTOMA
Optoma EH515T projector lamp 365W UHP 3000 hrs
365 W UHP replacement lamp module with housing for Optoma projectors, rated 3,000 hours life
- TypeUHP
- Wattage365W
- Lamp Life3,000 hrs
- Ready to install with pre-assembled bulb and housing
- 365 W UHP lamp matches original specifications
- Rated for 3,000 hours of projection time
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Direct replacement lamp
The Optoma EH515T lamp module arrives as a complete assembly with a new Philips UHP 365W bulb already mounted in its housing. It is built for owners of the matching Optoma projector who need a straightforward, ready-to-install replacement without separate bulb handling.
ISO9001 manufacturing
Each unit is produced to ISO9001 quality standards and tested for beam performance, ignition, voltage, connections and run-time before it ships. The pre-fitted housing means the lamp seats directly into the projector’s lamp compartment, so maintenance downtime stays minimal.
3,000-hour rated life
The UHP bulb is rated for 3,000 hours of operation at 365W, giving a clear interval for planning the next change. Buyers who need a longer service interval or a different wattage should look for a module specified accordingly.
Highlights
- Ready to install with pre-assembled bulb and housing
- 365 W UHP lamp matches original specifications
- Rated for 3,000 hours of projection time
- Manufactured to ISO 9001 quality standards
- Tested for beam performance, ignition and run-time
Specifications
| Brand | OPTOMA |
|---|---|
| Type | UHP |
| Wattage | 365W |
| Lamp Life | 3,000 hrs |
Questions about this item
What interface does the Optoma SP.72109GC01 lamp use and what wattage does it cap at?
The lamp uses the projector's native lamp connector and runs at 365W, matching the original specification.
What physical space does the assembled housing need inside the EH515T?
The module is a complete bulb-and-housing unit built to the exact dimensions of the original SP.72109GC01, so it fits the existing lamp compartment without modification.
How is the lamp installed and which step is most often missed?
Power off and cool the projector, open the lamp door, release the securing screw, slide the old module out, insert the new one until it seats firmly, re-tighten the screw, close the door, then reset the lamp timer in the menu — the timer reset is the step most users forget.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



