OPTOMA
OPTOMA BL-FU365 projector lamp 365W 3000 hrs
Replacement projector lamp module with a 365W UHP bulb rated for 3000 hours, supplied fully assembled for direct installation
- TypeUHP
- Wattage365W
- Lamp Life3,000 hrs
- 365W UHP bulb delivers bright projection
- 3000-hour lamp life supports extended use
- Pre-assembled module enables quick installation
- Manufactured to ISO9001 quality standards
- Genuine Philips UHP bulb inside housing
Replacement Lamp Module
The Optoma BL-FU365 is a complete projector lamp module that combines a new Philips UHP 365W bulb with its housing. It arrives fully assembled so you can install it straight into a compatible Optoma projector without extra tools or alignment steps.
Who This Suits
This unit suits owners of Optoma projectors that specify the BL-FU365 part number and want a ready-to-fit replacement with a rated 3,000-hour life. Buyers who need a bare bulb only, a different wattage, or a lamp coded for another projector series should look at other listings.
Deciding Specification
The lamp delivers 365 watts of UHP output and is rated for 3,000 hours of use. Matching that wattage and hour rating to your projector’s service manual is the single check that confirms this is the correct part.
Highlights
- 365W UHP bulb delivers bright projection
- 3000-hour lamp life supports extended use
- Pre-assembled module enables quick installation
- Manufactured to ISO9001 quality standards
- Genuine Philips UHP bulb inside housing
Specifications
| Brand | OPTOMA |
|---|---|
| Type | UHP |
| Wattage | 365W |
| Lamp Life | 3,000 hrs |
Questions about this item
Which Optoma projector models accept the BL-FU365 lamp module?
The BL-FU365 is designed as a direct replacement for Optoma projectors that originally shipped with this lamp module; verify your projector's manual lists the BL-FU365 part number before purchasing.
Will the 365W UHP bulb in this housing match the brightness and ignition characteristics of my projector's original lamp?
Yes, the module uses a genuine Philips UHP 365W bulb built to ISO9001 standards and tested for beam performance, ignition voltage and run-time to match the original specification.
How can I confirm the lamp is operating correctly after installation?
Reset the projector's lamp-hour counter to zero, then verify the on-screen timer begins counting from 0 hours and that the image reaches full brightness without flickering or error messages.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



