Eklind
Eklind 15132 SAE Hex Key 1/2 in Tip 5 1/4 in Long 1 5/8 in Short Arm
- Hex/Torx Keys
- Steel
$2.99
0.00003512BTC
In stock
Onsrud
Onsrud 60-124MW carbide hand tool
A carbide compression spiral router bit for laminated wood and MDF with a 3/8 inch cutter diameter
- TypeAngle, Pitch & Slope Locators
- MaterialCarbide
- Carbide construction resists wear for longer tool life
- Compression spiral design cuts cleanly on laminated wood and MDF
- 3/8 inch cutter diameter suits detailed routing tasks
- Onsrud engineering delivers reliable performance in hand-tool applications
- California Proposition 65 notice informs safe handling practices
Application focus
The Onsrud 60-124MW carbide routing end mill is built for laminated wood and MDF work. Its compression spiral geometry cuts cleanly on both faces of the panel. Woodworkers and cabinet makers who need chip-free edges on double-sided stock will find it suited to the task.
Thermal and power behaviour
As a solid carbide hand tool it generates no heat, draws no power and produces no mechanical noise during use. Cutting temperature and spindle load depend entirely on the router motor and feed rate chosen by the operator.
Deciding specification
The compression spiral design is the single feature that determines whether this bit matches the job. It prevents tear-out on the top and bottom surfaces of laminated panels in a single pass. Buyers who need a straight flute or up-cut only geometry should select a different tool.
Highlights
- Carbide construction resists wear for longer tool life
- Compression spiral design cuts cleanly on laminated wood and MDF
- 3/8 inch cutter diameter suits detailed routing tasks
- Onsrud engineering delivers reliable performance in hand-tool applications
- California Proposition 65 notice informs safe handling practices
Specifications
| Brand | Onsrud |
|---|---|
| Model | 60-124MW |
| Type | Angle, Pitch & Slope Locators |
| Material | Carbide |
Questions about this item
How do I install the 60-124MW compression spiral bit in my router collet and what step is often missed?
Insert the 3/8 in shank fully into the collet, tighten securely, and verify the compression spiral direction matches your feed direction; the step often missed is confirming the up-cut and down-cut sections align with the material thickness.
What maintenance will the carbide cutting edges on the 60-124MW require over time?
The solid carbide edges stay sharp longer than steel; inspect for chipping after heavy laminated wood or MDF runs and send to a specialist sharpening service when cut quality drops — no field sharpening is possible.
What limit appears first on the 60-124MW during sustained routing of laminated wood?
Heat buildup at the 3/8 in cutter diameter is the first limit; the compression spiral evacuates chips well, but continuous deep passes without pause will overheat the carbide and degrade edge life.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
