We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Coiled yellow nylon tubing, quarter-inch outside diameter, hundred-foot length

Nycoil

Nycoil 1/4" OD Nylon Tubing Yellow 100 ft

SKU CH-HDN7-QE0VS

Yellow nylon tubing rated 400 psi at 68°F, 100 ft length, 1/4 in OD, 11/64 in ID

  • Nylon construction resists abrasion and chemicals
  • 1/4 in outside diameter fits standard push-to-connect fittings
  • 100 ft coil reduces splice points in long runs
  • 400 psi at 68 Degrees F handles demanding air lines
  • Yellow colour simplifies circuit identification in busy panels

Product Identity

This yellow nylon tubing measures 1/4 inch outside diameter with an 11/64 inch bore and comes in a 100 ft length. It is suited for workshop air lines, pneumatic tool connections and general low-pressure fluid transfer.

Operating Limits

The tube handles 400 psi at 68 Degrees F and up to 175 Degrees F continuous temperature. Shore D 60 hardness gives a firm feel that resists kinking during routing. Vacuum rating reaches 28 in Hg for suction applications.

Installation Checklist

Verify that your fittings accept 1/4 inch OD tubing and that system pressure stays within the 400 psi limit at ambient temperature. Confirm chemical compatibility with the nylon material and note the Proposition 65 warning for regulated environments.

Highlights

  • Nylon construction resists abrasion and chemicals
  • 1/4 in outside diameter fits standard push-to-connect fittings
  • 100 ft coil reduces splice points in long runs
  • 400 psi at 68 Degrees F handles demanding air lines
  • Yellow colour simplifies circuit identification in busy panels

Specifications

BrandZORO SELECT

Questions about this item

How often should the 1/4 in OD nylon tubing be inspected or replaced when used at 400 psi?

Inspect regularly for cracks, kinks or abrasion; replace immediately if the yellow jacket shows wear or the 400 psi @ 68 °F rating can no longer be maintained.

What is the first limit reached during continuous airflow at the 400 psi rating?

The 175 °F maximum operating temperature is reached before the 28 in Hg vacuum limit, so sustained heat is the governing constraint.

Does the tubing become noisy or excessively hot when run all day at 400 psi?

Nylon construction runs quietly; surface temperature will approach the 175 °F ceiling under full load, so allow adequate ventilation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.