We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

NVX

NVX VAD17001 1700W RMS Class D Monoblock Car Amplifier

SKU CH-45SP-360K0

Delivers up to 1700W RMS at 1 ohm with marine-certified circuitry and a variable bass remote

  • TypeAmplifiers
  • 1700W RMS at 1 ohm for maximum subwoofer output
  • 3400W peak power handles demanding bass transients
  • Marine certified conformal coating protects against moisture and corrosion
  • Variable bass boost 0 to +12 dB at 45 Hz via included remote
  • Preamp RCA outputs allow daisy chaining multiple amplifiers

1700W RMS Monoblock Amplifier

The NVX VAD17001 is a Class D monoblock car amplifier rated at 1700W RMS into 1 ohm, 1350W RMS into 2 ohms and 800W RMS into 4 ohms. Peak power reaches 3400W. It is marine certified with a conformally coated circuit board for installation in boats, powersports vehicles or cars. A variable bass remote provides 0 to +12 dB boost at 45 Hz.

Sustained Output and Protection

The heavy-duty aluminium alloy heat-sink dissipates heat during extended high-power operation, while three-way protection circuitry guards against thermal, short-circuit and overload conditions. Platinum-plated RCA inputs and screw terminals maintain low-resistance connections under continuous current draw. Preamp RCA outputs allow daisy-chaining additional amplifiers without signal degradation over long runs.

Marine Certified Installation Limits

The conformal coating enables mounting in damp or salt-spray environments where standard amplifiers would corrode. Platinum plating on all signal and power terminals resists oxidation that would increase resistance over time. The single-channel topology limits the unit to one subwoofer load; systems requiring stereo amplification or multiple independent zones need separate amplifiers.

Impedance-Dependent Power Delivery

Maximum continuous output varies significantly with load impedance, delivering 1700W at 1 ohm, 1350W at 2 ohms and 800W at 4 ohms. Wiring multiple subwoofers to present a 1-ohm load extracts full rated power but demands adequate current supply and secure platinum-plated terminal connections. The 0 to +12 dB bass boost centred at 45 Hz shapes low-frequency response but does not alter the fundamental power limits imposed by the connected impedance.

Highlights

  • 1700W RMS at 1 ohm for maximum subwoofer output
  • 3400W peak power handles demanding bass transients
  • Marine certified conformal coating protects against moisture and corrosion
  • Variable bass boost 0 to +12 dB at 45 Hz via included remote
  • Preamp RCA outputs allow daisy chaining multiple amplifiers

Specifications

TypeAmplifiers

Questions about this item

How much heat does the 1700 W RMS monoblock produce when driven hard all day?

The heavy-duty aluminium alloy heat-sink is designed to dissipate heat during continuous high-power operation without a fan.

What source connections and power wiring must already be in the vehicle for this amplifier to work?

Platinum-plated RCA level inputs accept a pre-amp signal, and platinum-plated screw terminals connect power, ground and speaker wire.

Will the pre-amp RCA outputs let me keep my existing four-channel amp and add this monoblock for subwoofers?

Yes, the preamp RCA outputs daisy-chain a second amplifier so the original amp can stay in the system.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.