We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
NUOLAISUN replacement LCD touch screen for HP Envy 17-CR0013DX no bezel new condition

NUOLAISUN

NUOLAISUN N13553-001 For HP Envy 17-CR0013DX LCD Touch Screen Replacement No Bezel

SKU CH-221X-CCQ5Z

LCD touch-screen replacement for HP Envy 17-CR0013DX laptops, supplied without bezel

  • Direct replacement for HP Envy 17-CR0013DX
  • Touch-enabled LCD restores full input control
  • Screen-only package keeps installation focused
  • New condition ensures reliable visual quality
  • Verify part numbers before ordering to guarantee fit

HP Envy 17-CR0013DX LCD Touch Replacement

This NUOLAISUN N13553-001 panel is a new replacement LCD touch screen built specifically for the HP Envy 17-CR0013DX notebook. It arrives without a bezel, so the original frame must be reused during installation. The part is intended for repair technicians or experienced owners who can match the exact model numbers before fitting. Professional fitting is strongly advised because the component is fragile and ships without instructions.

Passive panel thermals and power draw

The screen draws power directly from the laptop's internal display connector and adds no active cooling of its own. In normal operation it runs at the thermal level dictated by the host system's own heat management. There are no fans, pumps or moving parts to generate noise, so the replacement does not change the acoustic profile of the notebook. Power consumption remains whatever the original panel required.

Bezel reuse and connector compatibility

Because the unit ships as a bare panel, the existing bezel, hinges and cables must be transferred from the damaged screen. The installer must disconnect both the power adapter and battery cable before starting work to avoid short circuits. Compatibility depends on matching the part number, pin count, resolution and refresh rate shown on the original screen's rear label. Buyers who cannot verify those details should not order this item.

Highlights

  • Direct replacement for HP Envy 17-CR0013DX
  • Touch-enabled LCD restores full input control
  • Screen-only package keeps installation focused
  • New condition ensures reliable visual quality
  • Verify part numbers before ordering to guarantee fit

Specifications

No published specifications for this item yet.

Questions about this item

How do I install the N13553-001 LCD touch screen into my HP Envy 17-CR0013DX without damaging the connector?

Disconnect the power adapter and the battery cable before starting. The package contains the LCD screen only with no bezel, so you must transfer the original bezel and hinge brackets. Route the 13-pin data cable carefully through the hinge channel and seat the connector fully before reassembling the display assembly.

What part of the N13553-001 will need replacement first if the backlight degrades or the touch layer fails?

The unit is a fused LCD and touch digitizer assembly; individual layers cannot be swapped. If the backlight dims unevenly or the touch sensor stops registering input across the 17-inch panel, the entire N13553-001 screen must be replaced as one component.

What is the first limitation that appears when the N13553-001 runs continuously at maximum brightness?

Sustained full brightness accelerates LED backlight ageing, causing gradual luminance loss and potential warm-colour shift across the panel. The 13-pin eDP interface and touch controller remain stable, so the backlight degradation is the primary limit during extended high-brightness operation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.