North American Herb & Spice
North American Herb & Spice 5 Conductor DMX Cable 328 foot roll
Five-conductor DMX cable on a 328 foot roll, double-shielded with 100% foil and aluminium braid for 110 ohm signal integrity
- TypeComponent Cables
- 328-foot roll covers long cable runs
- 110-ohm twisted pairs deliver loss-free DMX data
- 20-strand 0.12 AWG copper ensures reliable signal transfer
- 100% foil plus aluminium braid blocks RF and EMI noise
- Drain wire adds extra interference protection
Professional DMX Lighting Cable
The North American Herb & Spice 5 Conductor DMX Cable is built for professional lighting control in theatrical, broadcast and live sound environments. Its 328 foot roll suits installers who need long, continuous runs without splices. The five conductor design supports standard 3 pin DMX fixtures and controllers. It is not for buyers who need Ethernet based lighting protocols or fibre optic transmission.
Signal Capacity and Headroom
The cable uses a digital 110 ohm twisted pair construction with four conductors of 20 strands at .12 awg bare copper for maximum no loss data transmission. Heavy duty PE insulation maintains signal integrity over the longest cable runs. Double shielding with 100% foil cover and aluminium braided sleeve eliminates RF and EMI interference. It runs out of headroom when runs exceed the DMX specification limit or when connectors are mismatched.
Thermals Noise and Power Draw
The robust jacket and flexible cotton fill protect internal structure during repeated coil and uncoiling cycles. Double shielding prevents stray high and low frequency leakage that can disrupt smooth signal data transfer. No active electronics means zero power draw and silent operation. The drain wire ensures consistent grounding for reliable performance in electrically noisy venues.
Highlights
- 328-foot roll covers long cable runs
- 110-ohm twisted pairs deliver loss-free DMX data
- 20-strand 0.12 AWG copper ensures reliable signal transfer
- 100% foil plus aluminium braid blocks RF and EMI noise
- Drain wire adds extra interference protection
Specifications
| Type | Component Cables |
|---|
Questions about this item
Will the 110 ohm impedance of this 328 foot cable match the 3 pin DMX fixtures I already own?
Yes, the 110 ohm twisted pair design is built to the standard impedance for DMX lighting control, so it will work with your existing 3 pin DMX fixtures.
How can I verify the double shield is blocking RF and EMI after I install the cable?
A clean DMX signal with no flickering or delayed fixture response across the full 328 foot run confirms the foil and braided shields are rejecting interference.
Does the 328 foot roll come with connectors on both ends or do I buy 3 pin plugs separately?
The roll is supplied as bulk cable without connectors; you will need to purchase 3 pin DMX plugs separately to terminate each end.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



