Nippon Labs
Nippon Labs 30POW-10W1-14-02203 computer power extension cord 3ft 14AWG C14 to C13 black
A 3 ft 14 AWG extension cable with IEC-60320-C14 to IEC-60320-C13 connectors, rated 15A/250V, fully moulded for durability and UL, cUL and CSA approved
- TypeExtension Cable
- ColorBlack
- Length3 ft.
- Connector Number2
- SpecificationsConnector A: IEC-60320-C14 Connector B: IEC-60320-C13
- Wire Gauge14 AWG
- Extend reach by three feet with a 14 AWG extension
- Heavy-duty 14 AWG conductors handle 15 A at 250 V
- Fully moulded C14-to-C13 ends resist strain and wear
- UL, cUL and CSA approvals confirm safety compliance
- RoHS and REACH compliant materials reduce hazardous substances
Three-foot reach for rack gear
This three-foot extension cord connects a C14 inlet to a C13 outlet, letting you bridge the gap between a server, switch or workstation and a nearby PDU or UPS. The 14 AWG conductors are rated for 15 amps at 250 volts and carry UL, cUL and CSA approvals plus RoHS and REACH compliance. The fully moulded SJT jacket resists wear in dense cabinet runs.
Replaces short factory leads
When the stock cable on a power supply or appliance falls short of the rack’s vertical PDU, this cord adds the missing length without stacking adapters. It is worth the swap whenever the existing lead is 14 AWG or thinner and the run stays within three feet, keeping voltage drop negligible for typical 15-amp loads.
Handles 15-amp continuous draw
The 14 AWG copper handles a full 15-amp continuous load at 250 volts, so it powers most single-supply servers, storage arrays and network gear without headroom concerns. It runs out of reach for equipment mounted farther than three feet from the power strip, and it cannot serve devices that demand a heavier gauge or a different connector standard.
Highlights
- Extend reach by three feet with a 14 AWG extension
- Heavy-duty 14 AWG conductors handle 15 A at 250 V
- Fully moulded C14-to-C13 ends resist strain and wear
- UL, cUL and CSA approvals confirm safety compliance
- RoHS and REACH compliant materials reduce hazardous substances
Specifications
| Brand | Nippon Labs |
|---|---|
| Model | 30POW-10W1-14-02203 |
| Type | Extension Cable |
| Color | Black |
| Length | 3 ft. |
| Connector Number | 2 |
| Specifications | Connector A: IEC-60320-C14 Connector B: IEC-60320-C13 |
| Wire Gauge | 14 AWG |
| Conductor | UL SJT 14 AWG. x 3C |
| Features | Extend the length of an existing power cord for more flexibility. Connect computer equipment to a PDU or UPS in data center. This heavy duty 14 AWG power cord is fully molded for durability. UL, cUL listed and CSA approved. All relevant materials are complied with RoHS and REACH directive. |
| Shipping weight | 0.16 kg |
| Package size | 203 × 152 × 20 mm |
Questions about this item
Will the 14 AWG SJT cable and moulded C14 plug fit side-by-side in a high-density PDU strip?
The cord uses a standard IEC-60320-C14 plug on a 14 AWG SJT jacket; it fits any C13 outlet, but allow enough rear clearance for the moulded body and the cable bend radius in tight rows.
What is the correct orientation when plugging the C14 end into a UPS and the C13 end into a server?
Insert the C14 connector into the UPS or PDU outlet and the C13 connector into the device inlet; both are keyed so they only go in one way — do not force them or the pins can bend.
How often should I inspect or replace this 3 ft 14 AWG extension cord in a data-centre rack?
Visually check the moulded connectors and SJT jacket during routine rack audits; replace the cord if you see cracks, discoloration, overheating marks or if the retention clips no longer hold securely.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Black Box Corporation
Black Box Corporation CAT6 EZ-RJ45 Modular Plugs 100-Pack
$95.99
0.0011546BTC
In stock
