We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper end cap, 4 inch nominal size, wrot copper finish

Nibco, Inc.

Nibco, Inc. 617 4 in Copper Cap

SKU CH-2VX8-HPCKG MPN 617

A 4-inch wrought-copper cap fitting rated to 293 psi at 100 °F and temperatures from -20 °F to 400 °F, meeting ASME/ANSI B 16.22

  • TypeDrain Components
  • MaterialHAWA
  • Copper construction resists corrosion
  • Handles up to 293 psi at 100 degrees Fahrenheit
  • Operates from minus 20 to 400 degrees Fahrenheit
  • Meets ASME/ANSI B16.22 standard

Copper Cap for 4-inch Drain Lines

The Nibco 617 cap terminates a 4-inch nominal copper drain line with a wrought copper fitting. It uses a sweat connection type and fits tubing with a 4-1/8 inch outside diameter. The component meets ASME/ANSI B16.22 standards for drain, waste and vent systems.

Suits installers closing a 4-inch copper stack

This cap serves plumbers who need a permanent, pressure-rated seal on 4-inch copper piping rated to 293 psi at 100 degrees Fahrenheit. It is not for buyers who require a threaded, compression or push-fit connection, nor for those needing a cleanout access point or a different pipe diameter.

Highlights

  • Copper construction resists corrosion
  • Handles up to 293 psi at 100 degrees Fahrenheit
  • Operates from minus 20 to 400 degrees Fahrenheit
  • Meets ASME/ANSI B16.22 standard

Specifications

TypeDrain Components
MaterialHAWA
BrandNibco
Model617 4

Questions about this item

What copper tube size must already be in place for the 617 4 cap to fit?

The cap is made for a 4 in nominal tube with a 4-1/8 in outside diameter, so that exact copper tube must be present for a solder joint.

Can the cap handle the pressure and temperature of an existing hydronic loop?

It is rated to 293 psi at 100 °F and a temperature range of -20 °F to 400 °F, covering typical hydronic conditions.

How do I confirm the joint is sound after soldering the cap?

Pressurise the system to its working pressure — up to 293 psi — and inspect the soldered joint for leaks.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.