We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper reducing tee with three sweat cup connections, 2 inch by 1 inch by 1 inch

Nibco, Inc.

Nibco, Inc. 611 Reducing Tee Copper 2x1x1 in

SKU CH-17XX-2CEC8

A sweat-fitting reducing tee joins 2 in, 1 in and 1 in copper tubes for potable-water systems

  • Reduces flow from 2 in to 1 in branches
  • Sweat connections enable leak-free solder joints
  • Wrot copper construction resists corrosion in potable water
  • Reducing tee design joins three copper tube sizes
  • Suitable for potable water supply installations

NIBCO 611 Copper Reducing Tee

This NIBCO 611 reducing tee connects a 2-inch copper main to two 1-inch branches using sweat cup connections on all three outlets. It is made from wrought copper for potable water systems and suits plumbers running new supply lines or altering existing copper pipework.

Replaces mismatched bushings and separate couplings

Using a single factory-made tee removes the leak paths and alignment hassles that come from joining a 2-inch line to 1-inch drops with multiple fittings. The jump is worth it whenever a clean, code-compliant branch is needed without stacking adapters.

Sweat installation requires flux, solder and a torch

Clean each tube end, apply flux, assemble the joint and heat evenly until solder flows into the cup. The main pitfalls are overheating the fitting, which burns the flux, and leaving debris inside the tubes, both of which cause pinhole leaks after pressure testing.

Highlights

  • Reduces flow from 2 in to 1 in branches
  • Sweat connections enable leak-free solder joints
  • Wrot copper construction resists corrosion in potable water
  • Reducing tee design joins three copper tube sizes
  • Suitable for potable water supply installations

Specifications

BrandNibco

Questions about this item

What copper tube sizes does the 2 in x 1 in x 1 in reducing tee accept on each outlet?

The run takes 2 in copper tube and each branch takes 1 in copper tube, matching the listed copper tube sizes for sides A, B and C.

How do I make a leak-free sweat joint on the cup ends of this fitting?

Clean tube ends and fitting cups with emery cloth, apply flux, insert tubes fully, heat evenly with a torch and feed solder until the joint rings completely.

Will the wrot copper body need any corrosion-related replacement in potable water service?

Wrot copper resists corrosion in potable water; no scheduled replacement is required unless mechanical damage or dezincification occurs.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.