We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper 90-degree long-radius elbow with sweat ends, 1-1/2 inch nominal

Nibco, Inc.

Nibco, Inc. 60722LT 1-1/2" Copper 90 Degree Long Radius Elbow

SKU CH-TJFR-TD7QT

A wrot-copper 90-degree long-radius elbow for sweat-joint plumbing systems carrying air, gases or potable water up to 577 psi at 200 °F and 400 °F maximum temperature

  • Sweat connection simplifies copper pipe installation
  • Long-radius 90° elbow reduces flow restriction
  • Wrot copper construction resists corrosion in potable water
  • Rated for 577 psi at 200°F operating pressure
  • Withstands temperatures up to 400°F for hot-water systems

1-1/2" Copper Sweat Elbow

This NIBCO wrot-copper 90-degree long-radius elbow joins two 1-1/2" copper tubes in potable-water, air or gas lines. The fitting accepts a tube outer diameter of 1-5/8" on each end and is rated for 577 psi at 200°F.

Sweat installation notes

Clean tube ends and fitting sockets thoroughly, apply flux, then heat evenly with a torch until solder flows into the joint. Overheating can damage the copper or weaken the bond, while insufficient heat leaves voids that leak under pressure.

577 psi at 200°F pressure rating

This single figure defines the safe operating envelope for hot-water heating, compressed-air or gas distribution systems. Installations that exceed either the pressure or temperature limit require a different fitting class.

Highlights

  • Sweat connection simplifies copper pipe installation
  • Long-radius 90° elbow reduces flow restriction
  • Wrot copper construction resists corrosion in potable water
  • Rated for 577 psi at 200°F operating pressure
  • Withstands temperatures up to 400°F for hot-water systems

Specifications

BrandNIBCO

Questions about this item

How do I confirm the elbow is correctly installed for potable water at 577 psi?

After soldering, pressurise the line to the rated 577 psi at 200 °F and inspect every joint for leaks; a dry test confirms the wrought copper fitting is working as intended.

What comes in the box and what must I supply for a sweat connection?

The box contains only the 1-1/2" long-radius elbow; you must provide copper tube, flux, lead-free solder and a torch to complete the sweat joints.

Which version suits a 1-1/2" copper line needing a 90-degree turn?

The 60722LT is the 1-1/2" nominal, 90-degree long-radius elbow rated to 577 psi and 400 °F, matching that tube size and bend requirement.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.