Advance Tabco
Advance Tabco FC-1-1818-X Wall Mounted Sink 18 in x 18 in, 304
- Silver
$790.99
0.00937525BTC
In stock
Nibco, Inc.
Nibco, Inc. 606 5/8 in 45° Copper Elbow Cup×Cup
A 45-degree copper sweat elbow joins two 5/8 in tubes for air, gases or potable water up to 631 psi at 100 °F
- ColorTransparent
- TypePipes, Valves & Fittings
- Directs flow at 45° for smooth routing
- Wrot copper construction resists corrosion in potable water
- Cup-to-cup sweat ends join 5/8 in copper tube
- Rated 631 psi at 100 °F for reliable pressure handling
- Withstands 400 °F maximum operating temperature
Copper Sweat Fitting Elbow
This NIBCO 606 elbow joins two 5/8-inch copper tubes at a 45-degree angle using cup-to-cup sweat connections. It is made from wrot copper and rated for air, gases and potable water systems. The fitting suits plumbers and HVAC installers who need a standard directional change in copper pipework.
Simple Sweat Installation
The cup ends slide over clean, fluxed tube and are soldered with a torch; no threading, pressing or special tools are required beyond normal sweating practice. Leaks usually come from insufficient cleaning, poor flux coverage or overheating the joint. Correct tube preparation and even heat avoid most callbacks.
Pressure And Temperature Headroom
The elbow withstands up to 631 psi at 100 °F and continuous temperatures up to 400 °F, giving ample margin for typical residential hot-water and low-pressure gas lines. It runs out of headroom in high-pressure steam or industrial process piping that exceeds either limit.
Highlights
- Directs flow at 45° for smooth routing
- Wrot copper construction resists corrosion in potable water
- Cup-to-cup sweat ends join 5/8 in copper tube
- Rated 631 psi at 100 °F for reliable pressure handling
- Withstands 400 °F maximum operating temperature
Specifications
| Brand | NIBCO |
|---|---|
| Color | Transparent |
| Type | Pipes, Valves & Fittings |
Questions about this item
How can I confirm the 45° copper elbow is sealed correctly after soldering?
Pressure-test the joint up to 631 psi at 100 °F and inspect for leaks; the wrought copper fitting is rated for 400 °F maximum operating temperature.
What comes with the 606 elbow and what must I supply?
The fitting itself is included; you must provide 5/8 in copper tube (¾ in OD), flux, solder and a torch for the sweat connections.
Which NIBCO 606 version suits a 5/8 in copper line?
This model is a 45° cup×cup elbow for 5/8 in CTS (¾ in OD) tube on both ends, rated 631 psi at 100 °F.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
