We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Copper straight reducing coupling, larger end fitting, smaller end cup, metallic finish

Nibco, Inc.

Nibco, Inc. 6002 1-1/4" x 1/2" Copper Reducer

SKU CH-2F67-AV7BT MPN 6002

Straight reducing coupling joins 1 1/4 in and 1/2 in copper tubes for air, gases or potable water up to 439 psi at 100 degrees F and 400 degrees F

  • TypeDrain Components
  • MaterialHAWA
  • Reduces 1-1/4" tube to 1/2" with straight copper coupling
  • Handles 439 psi at 100 Degrees F for high-pressure lines
  • Withstands 400 Degrees F for hot water or steam service
  • Wrot copper construction resists corrosion in potable water systems
  • FTG and Cup ends enable sweat solder installation

Copper Reducing Coupling 1-1/4" x 1/2

This wrot copper reducing coupling joins a 1-1/4 inch tube to a 1/2 inch tube in plumbing systems. It handles potable water, air and gases with a straight reducing shape. The fitting uses a sweat connection on both ends for permanent soldered joints. It is rated for 439 psi at 100 degrees F and up to 400 degrees F.

Sweat FTG x Cup Connections

The FTG end fits inside a 1-1/4 inch copper fitting while the cup end accepts a 1/2 inch copper tube. This replaces a bushing or two separate couplings when reducing pipe size in a single joint. The jump is worth it when a compact, leak-resistant transition is required without additional fittings.

Soldered Joint Temperature Limit

The copper material and sweat joint design limit use to the 400 degree F maximum operating temperature. Exceeding this temperature can weaken the solder bond and the fitting itself. The 439 psi pressure rating applies only at the lower 100 degree F reference point. Installers must verify system temperatures stay within this range.

Highlights

  • Reduces 1-1/4" tube to 1/2" with straight copper coupling
  • Handles 439 psi at 100 Degrees F for high-pressure lines
  • Withstands 400 Degrees F for hot water or steam service
  • Wrot copper construction resists corrosion in potable water systems
  • FTG and Cup ends enable sweat solder installation

Specifications

TypeDrain Components
MaterialHAWA
BrandNibco
Model6002 11/4x1/2

Questions about this item

What tube outer diameters must match the 1 3/8 in and 5/8 in ends of this copper reducer?

The FTG end accepts a 1 3/8 in copper tube and the cup end accepts a 5/8 in copper tube.

Which joint should be soldered first to avoid trapping flux inside the 6002 reducer?

Solder the cup end to the 1/2 in tube first, then insert the FTG end into the 1 1/4 in fitting and solder that joint.

When should the reducer be inspected or replaced given its 439 psi rating at 100 Degrees F?

Inspect joints annually for green corrosion or leaks; replace if pressure tests exceed 439 psi or temperature exceeds 400 Degrees F.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.