We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two green DDR5 UDIMM sticks, no heat spreaders, 288 pins each

NEMIX RAM

NEMIX RAM 64GB (2x32GB) DDR5 5600 CL46 2Rx8 1.1V UDIMM for ASRock IMB-1315/1318

SKU CH-PGV7-AXAMK

A 64 GB dual-channel DDR5 kit running at 5600 MT/s with CL46 latency, built for ASRock IMB-1315 and IMB-1318 industrial boards

  • Capacity64GB (2 x 32GB)
  • SpeedDDR5 5600 (PC5 44800)
  • ECCNo
  • Buffered/RegisteredUnbuffered
  • ChipsetMajor OEM Samsung, Micron, Hynix
  • Voltage1.10V
  • 64 GB total capacity from two 32 GB modules
  • DDR5 5600 speed rated at PC5-44800 bandwidth
  • CL46 CAS latency for responsive operation
  • Low 1.1 V voltage reduces power draw
  • Validated for ASRock IMB-1315 and IMB-1318 motherboards

ASRock IMB-1315/1318 DDR5 memory kit

This 64 GB kit contains two 32 GB DDR5 UDIMMs validated for ASRock Industrial Micro-ATX motherboards IMB-1315 and IMB-1318. The modules run at 5600 MT/s with CL46 latency at 1.1 V. They are non-ECC and unbuffered, matching the board's standard desktop memory layout.

288-pin unbuffered modules without heat spreaders

Each stick uses a 288-pin DDR5 edge connector and a 2Rx8 organisation built from major OEM Samsung, Micron or Hynix chips. The bare-PCB design keeps the profile low for tight industrial chassis, and the 1.10 V operating voltage matches the platform's default DDR5 rail. No extra power cables or firmware steps are required.

Verify board revision and slot population rules

Confirm your motherboard is an IMB-1315 or IMB-1318 revision that supports 32 GB single-rank densities and dual-channel operation with two UDIMMs. Check the manual for any BIOS version requirement before installing, and ensure the CPU memory controller is rated for 5600 MT/s operation. Builders needing ECC, registered DIMMs or higher capacities should look elsewhere.

Highlights

  • 64 GB total capacity from two 32 GB modules
  • DDR5 5600 speed rated at PC5-44800 bandwidth
  • CL46 CAS latency for responsive operation
  • Low 1.1 V voltage reduces power draw
  • Validated for ASRock IMB-1315 and IMB-1318 motherboards

Specifications

BrandNEMIX RAM
SeriesNEMIX RAM Original Series Memory
ModelDDR5 Non-ECC Unbuffered UDIMM Memory
Part NumberMD44800-328K2
Capacity64GB (2 x 32GB)
SpeedDDR5 5600 (PC5 44800)
ECCNo
Buffered/RegisteredUnbuffered
ChipsetMajor OEM Samsung, Micron, Hynix
Voltage1.10V
Compatible SystemASRock Industrial
CAS LatencyCL46
Heat SpreaderNo
Type288-Pin DDR5 UDIMM
Rank2Rx8
FeaturesDDR5 Non-ECC Unbuffered UDIMM Motherboard Compatible
Package Content64GB (2 x 32GB) DDR5 5600MHz PC5-44800 2Rx8 1.1V 288-PIN Non-ECC UDIMM KIT

Questions about this item

What speed does the DDR5 5600 interface run at on the ASRock IMB-1315 and IMB-1318?

The kit operates at DDR5 5600 (PC5-44800) with CL46 latency at 1.1 V on the listed ASRock boards.

Will the 288-pin UDIMM modules fit the Micro-ATX IMB-1315 and IMB-1318 motherboards?

Yes, each 32 GB module uses the standard 288-pin DDR5 UDIMM form factor required by those boards.

How do I install the two 32 GB sticks and which slot order avoids the common mistake?

Power off, open the chassis, align each module's notch with the slot key, press firmly until the retention clips click, then verify both sticks are seated in the correct channel pair per the board manual.

New to this? Buying memory and SSDs with crypto — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.