NEC Display Solutions
NEC NP200A (NP10LP) 180W Projector Lamp
Genuine 180 W replacement lamp module with 3,500-hour rated life for NEC projectors
- TypeProjector Lamp
- Wattage180W
- Lamp Life3,500 Hrs.
- 180W NSH bulb powers bright projection
- 3,500-hour lamp life reduces replacement frequency
- Fully assembled housing enables quick installation
- ISO 9001 manufacturing ensures consistent quality
- Genuine NEC NP10LP module guarantees projector compatibility
NEC NP200A 180W Projector Lamp
The NEC NP200A is a genuine compatible replacement projector lamp rated at 180 watts. It arrives as a fully assembled bulb and housing module for direct installation in supported NEC projectors. The NSH lamp delivers a rated life of 3,500 hours under normal operating conditions.
For NEC projector owners needing a ready-to-fit
This unit suits users who want a complete housing assembly that requires no separate bulb handling. It is not intended for projectors that accept a different wattage or connector type, nor for buyers who prefer a bare bulb without the housing. Verify the exact model compatibility before ordering.
180W NSH lamp with 3,500-hour rated life
The 180 watt NSH bulb determines brightness output and replacement interval for the projector. A 3,500 hour rating sets the expected service window before a new lamp is required. Match this wattage and life specification to the projector's original requirements to ensure correct operation.
Highlights
- 180W NSH bulb powers bright projection
- 3,500-hour lamp life reduces replacement frequency
- Fully assembled housing enables quick installation
- ISO 9001 manufacturing ensures consistent quality
- Genuine NEC NP10LP module guarantees projector compatibility
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 180W |
| Lamp Life | 3,500 Hrs. |
Questions about this item
Which NEC projectors accept the NP200A lamp module?
The NP200A module fits NEC projectors that list NP10LP as the replacement lamp; check your projector manual for the NP10LP part number before ordering.
Will the 180 W lamp run in a projector that originally shipped with a lower-wattage module?
Only install the NP200A in projectors specified for an 180 W NSH lamp; using it in a unit designed for a different wattage can cause overheating or ignition failure.
How do I confirm the new lamp is operating correctly after installation?
Reset the projector's lamp-hour counter to zero, then verify the on-screen timer advances normally and the image reaches full brightness within the first 3,500 hours of use.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



