NEC Display Solutions
NEC NP1000G Projector Lamp 300W 2000 Hrs
A 300 W replacement lamp module with a 2,000-hour rated life, supplied as a fully assembled bulb and housing for NEC projectors
- TypeProjector Lamp
- Wattage300W
- Lamp Life2,000 Hrs.
- Genuine 300W NSH lamp delivers 2,000 hours runtime
- Pre-assembled housing enables tool-free installation
- ISO 9001 manufacturing ensures consistent beam performance
- OEM-grade components match original projector specifications
- Compatible with NEC NP1000G projector models
Genuine Replacement Lamp Module
The NEC NP1000G is a complete 300W lamp module with housing, designed as a direct replacement for compatible NEC projectors. It arrives fully assembled so the projector is ready to run immediately after fitting.
Simple Swap-In Installation
The unit slots into the projector without tools or alignment steps beyond the normal lamp-door procedure. The only common issue is forgetting to reset the lamp-hour counter in the projector menu after installation, which leaves the replacement warning active.
2,000-Hour Rated Service Life
At 300W the lamp delivers up to 2,000 hours of typical use before brightness drops to half. Heavy daily operation will reach that limit faster, while occasional presentations can extend the practical interval well beyond the rated figure.
Highlights
- Genuine 300W NSH lamp delivers 2,000 hours runtime
- Pre-assembled housing enables tool-free installation
- ISO 9001 manufacturing ensures consistent beam performance
- OEM-grade components match original projector specifications
- Compatible with NEC NP1000G projector models
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 300W |
| Lamp Life | 2,000 Hrs. |
Questions about this item
How can I verify the 300 W NSH bulb is operating correctly after installation?
Check the projector menu for the lamp-hour counter resetting to zero and confirm the image reaches full brightness without flickering during the first 30 minutes of use.
What components are included and what must be purchased separately?
The module arrives as a fully assembled 300 W NSH bulb inside its housing; no extra parts are required for installation.
Which NP1000G version should I select for my NEC projector?
Choose the OEM version from the original bulb manufacturer for exact factory performance, the NEC-sold OEM for brand-matched support, an alternative OEM version for equivalent specs, or the compatible version for a lower-cost option using genuine OEM parts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



