NEC Display Solutions
NEC Display Solutions VT495 VT85LP Projector Lamp 200W
A 200 W replacement lamp module with housing delivers 2,000 to 3,000 hours of life for NEC projectors
- TypeProjector Lamp
- Wattage200W
- Lamp Life2,000 (Normal) - 3,000 (Economy) Hrs.
- Ready-to-install module with 200 W Ushio NSH bulb
- 2 000 hrs normal or 3 000 hrs economy lamp life
- OEM-spec quality from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
- Each unit tested for beam performance, ignition, voltage and run-time
- ISO 9001 manufacturing ensures consistent reliability
NEC VT495 Lamp Module
The NEC VT495 lamp module (model VT85LP) is a 200W replacement projector lamp supplied as a fully assembled bulb and housing. It is designed for users who need a direct, ready-to-fit spare for compatible NEC projectors. The lamp uses a Ushio NSH 200W bulb and is built to ISO9001 quality standards.
200W Wattage Match
The single specification that decides fit is the 200W rating; the lamp must match the projector's original wattage to operate correctly and achieve the rated 2,000 hours in normal mode or 3,000 hours in economy mode. Using a different wattage will cause ignition or brightness failures.
Simple Housing Swap
Installation consists of removing the old lamp housing and inserting the new module until it seats firmly; no separate bulb handling or alignment is required. The most common issue is forgetting to reset the projector's lamp-hour counter after replacement, which leaves the replacement warning active.
Highlights
- Ready-to-install module with 200 W Ushio NSH bulb
- 2 000 hrs normal or 3 000 hrs economy lamp life
- OEM-spec quality from Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita
- Each unit tested for beam performance, ignition, voltage and run-time
- ISO 9001 manufacturing ensures consistent reliability
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 200W |
| Lamp Life | 2,000 (Normal) - 3,000 (Economy) Hrs. |
Questions about this item
How bright will the 200W NSH bulb be in my projector?
The 200W NSH bulb delivers the original brightness specified for the VT495 projector; actual lumen output depends on the projector's optical engine and selected mode.
Does the VT85LP module use a standard lamp connector?
The lamp module is built to the NEC VT495 specification and plugs directly into the projector's proprietary lamp socket without adapters.
Will the assembled housing fit the VT495 projector without extra brackets?
Yes, the bulb comes pre-installed in a housing matched to the VT495 chassis, so it slides into the lamp compartment and secures with the existing screws.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



