We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
NEC PE410H projector lamp module with Philips 260W UHP bulb in housing

NEC Display Solutions

NEC Display Solutions PE410H NP34LP projector lamp 260W 3000 hrs

SKU CH-DF02-GXWF9

Genuine 260W UHP replacement lamp module rated for 3000 hours, supplied fully assembled for immediate installation

  • TypeUHP
  • Wattage260W
  • Lamp Life3,000 hrs
  • Genuine Philips 260W UHP bulb delivers reliable brightness
  • 3,000-hour rated life reduces replacement frequency
  • Pre-assembled housing enables quick tool-free installation
  • Manufactured to ISO9001 quality standards for consistent performance
  • Compatible with NEC PE410H projector models

Ready-to-install lamp module

The NEC PE410H NP34LP projector lamp ships as a fully assembled bulb and housing, so it fits straight into the projector without extra steps. It uses a Philips UHP bulb rated at 260 watts and delivers a rated life of 3000 hours under normal use. This module is built for owners of compatible NEC projectors who need a direct replacement that is ready to run.

ISO9001 manufacturing and OEM sourcing

Each unit is produced to ISO9001 standards and sourced from original bulb makers such as Philips, Osram, Ushio, Phoenix, Iwasaki or Matsushita, with genuine compatible versions also available. The housing aligns with the projector's mounting points and electrical connectors, allowing a straightforward swap that restores full brightness and colour performance. No adapters or modifications are required for daily operation.

Replaces worn or failed original lamps

This lamp replaces the factory-installed module when output has dimmed or the hour counter has reached its limit, bringing the projector back to its original light level. The upgrade is worth it when image quality has dropped below acceptable levels for presentations, classrooms or home cinema. It is not suited for users who need a higher-wattage alternative or a different lamp technology than the specified 260W UHP design.

Highlights

  • Genuine Philips 260W UHP bulb delivers reliable brightness
  • 3,000-hour rated life reduces replacement frequency
  • Pre-assembled housing enables quick tool-free installation
  • Manufactured to ISO9001 quality standards for consistent performance
  • Compatible with NEC PE410H projector models

Specifications

BrandNEC
TypeUHP
Wattage260W
Lamp Life3,000 hrs

Questions about this item

What lamp interface does the NEC NP34LP module use, and what wattage does that limit it to?

The module uses a UHP lamp rated at 260W, so the projector's power supply and ignition circuit are designed for that exact wattage.

What physical dimensions must the projector's lamp compartment accommodate for the NP34LP housing?

The NP34LP is supplied as a fully assembled bulb-and-housing unit built to fit the NEC PE410H projector's original lamp cage without modification.

How is the NP34LP lamp module installed, and which step do users most often miss?

Power off and unplug the projector, let it cool, remove the lamp cover, release the retaining screws, slide the old module out, insert the new NP34LP until it seats firmly, re-tighten the screws, replace the cover, then reset the lamp-hour counter in the menu — the reset is the step most often forgotten.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.