NEC Display Solutions
NEC Display Solutions PA600X OEM Replacement Projector Lamp 230W 3000 Hrs
A 230W replacement lamp module with 3,000-hour life for NEC PA600X projectors
- TypeProjector Lamp
- Wattage230W
- Lamp Life3,000 Hrs.
- Ready-to-install module with 230 W Ushio UHP bulb
- 3 000-hour rated life for extended projector uptime
- OEM-quality lamp built to ISO 9001 manufacturing standards
- Direct replacement for NEC PA600X (NP21LP) projectors
- Fully assembled housing eliminates separate bulb fitting
Ready-to-install replacement lamp
The NEC PA600X replacement lamp module arrives as a fully assembled 230 W UHP bulb inside its housing, so it fits directly into the projector without extra assembly. It is built for users who need a straightforward swap to restore brightness in compatible NEC projectors.
ISO 9001 manufacturing and OEM sourcing
Each unit is produced under ISO 9001 quality controls and sourced from original bulb makers such as Ushio, Philips, Osram, Phoenix, Iwasaki or Matsushita, or from leading third-party compatible lines. The finished module is tested for beam performance, ignition, voltage, connections and run-time before it ships.
3 000-hour rated life defines the service window
The lamp is rated for 3 000 hours of operation, after which brightness and colour stability will gradually decline and a further replacement will be required. Buyers who need longer intervals between changes should note that this module does not offer an extended-life rating beyond the stated figure.
Highlights
- Ready-to-install module with 230 W Ushio UHP bulb
- 3 000-hour rated life for extended projector uptime
- OEM-quality lamp built to ISO 9001 manufacturing standards
- Direct replacement for NEC PA600X (NP21LP) projectors
- Fully assembled housing eliminates separate bulb fitting
Specifications
| Brand | NEC |
|---|---|
| Type | Projector Lamp |
| Wattage | 230W |
| Lamp Life | 3,000 Hrs. |
Questions about this item
Does the NP21LP lamp module use a standard UHP 230W bulb interface?
Yes, it contains a new Ushio UHP 230W bulb inside the housing, matching the projector's original lamp specification.
Will the assembled housing fit the PA600X without extra brackets?
The module is a fully assembled bulb and housing built to the NP21LP form factor, so it slides directly into the projector's lamp compartment.
What is the correct reset step after installing the NP21LP lamp?
After fitting the module, use the projector's menu to reset the lamp-hour counter to zero; the lamp will then track its 3,000-hour rated life accurately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
CHIEF MANUFACTURING CMS018 18" 457 mm Fixed Extension Column projector accessory
- Extension Column
- Projector



